Siemens EcoView Installation Instructions Manual
Download Installation instructions manual of Siemens EcoView Control Unit, Thermostat for Free or View it Online on All-Guides.com.
Brand: Siemens
Category: Control Unit , Thermostat
Type: Installation instructions manual for Siemens EcoView
Pages: 7
1
2
3
4
5
6
7
Installation Instructions
Document No. 129-566
December 19, 2011
EcoView™ Thermostat
Item Number 129-566, Rev. BA Page 1 of 7
Product Description
This document covers the installation and
commissioning of the EcoView™ thermostat and
sensors components the EcoView system.
See the following documents for installation of other
EcoView system components:
• EcoView™ 8 DO Module Installation and
Commissioning (
129-565)
•
EcoView™Multi-phase Meter Installation
Instructions (129-563)
•
EcoView™ Touchscreen Installation and
Commissioning (
129-562)
Product Number
97-001 EcoView Thermostat
Caution Notations
CAUTION:
Equipment damage or loss of
data may occur if you do not
follow the procedures as
specified.
Required Tools
• Screwdriver
• Electric drill
Expected Installation Time
15 minutes
CAUTION:
If thermostat security enclosures are
required, they must be non-metallic so they
will not interfere with the radio transmission.
Prerequisites
• Power off the AC unit before attempting
removal of the existing thermostat.
• Thermostat wires are typically color coded. If
not, you must make note of which terminal
designator each wire was attached to.
• This thermostat is a direct replacement and
should accept the same wires. However, if
the AC unit is configured as a heat pump,
there are settings that can be adjusted in the
configuration menu on the thermostat.
• Remove the existing thermostat before
proceeding.
• Ensure that there is 24 Vac present at the
COM and RH terminals. If it is not present,
ensure that it is run from the HVAC unit.
COM is typically the blue wire, although on
some thermostats it can be a black wire.
Installation
1. Remove the base plate from the thermostat
housing by pulling straight up.
2. Install the thermostat base plate.
a. Feed the existing wires through the opening
in the base plate.
b. Secure the base plate to the mounting
surface using appropriate hardware.
Figure 1. Thermostat Base Plate.
NOTE: If 24 Vac was present at the
thermostat, skip Step 3 and proceed
to Step 4.