Chamberlain 916GA User Manual

Download Operation & user’s manual of Chamberlain 916GA Other for Free or View it Online on All-Guides.com.

Brand: Chamberlain

Category: Other

Type: Operation & user’s manual for Chamberlain 916GA

Pages: 4 (2.33 Mb)

Download Chamberlain 916GA Operation & user’s manual

Chamberlain 916GA Operation & user’s manual - Page 1
1
Chamberlain 916GA Operation & user’s manual - Page 2
2
Chamberlain 916GA Operation & user’s manual - Page 3
3
Chamberlain 916GA Operation & user’s manual - Page 4
4
Danger
Inside Property
®
IMPORTANT INFORMATION ABOUT THE SAFETY SENSORS
When properly connected and aligned, the sensor will detect an obstacle
in the path of its electronic beam. If an obstruction breaks the light beam
while the gate is CLOSING, the gate will stop and reverse to full open
position. If an obstruction breaks the light beam while the gate is
OPENING, the gate will stop.
The sensors must be installed so that the sending and receiving eyes
face each other across the gate, no more than 24" (61 cm) above the
ground. The sensors can be installed on the left or right of the gate as
long as the sun never shines directly into the receiving eye lens.
The safety sensors must be securely fastened to a solid surface such as
metal or a treated wood post (not provided). The light beam path must
be unobstructed during normal operation of the gate.
NOTE: Due to the variety of gates and mounting applications, PVC
conduit, wire, and posts are not provided. Refer to your local hardware
store for additional hardware.
Brackets
Safety Sensors
Hex Head Bolt (2)
Wing Nut (2)
Wire Nut (4)
ENTRAPMENT
Safety Sensors
Entrapment
DangerDanger
THE PROTECTOR SYSTEM
®
SAFETY SENSORS MODEL 916GA
CARTON INVENTORY
Verify carton inventory below.
OPEN and ENTRAPMENT Safety Sensors
CLOSE Safety Sensors
CLOSE
Safety Sensors
OPEN
Safety Sensors
The 916GA Safety Sensor Kit is compatible with Chamberlain
®
Gate
Access Systems GA400D, GA420D, and GA200D. The Safety Sensors
are designed to detect an obstacle in the path of the electronic beam
and stop the gate operator.
To prevent SERIOUS INJURY or DEATH:
• DISCONNECT power BEFORE installing the safety sensors.
• Correctly connect and align the safety sensors.
• Install the sensor so beam is NO HIGHER than 24" (61 cm) above
ground.
• Gate MUST be fully closed BEFORE installing the safety sensors.
• This product is for use with Chamberlain
®
GA400D, GA420D, and
GA200D gate operators ONLY. Use with other than recommended
equipment voids warranty, and may cause property damage or
SERIOUS personal INJURY.
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
WARNING
CAUTION
WARNING
WARNINGWARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIAADVERTENCIA
1