Casio 1517 User's Manual

Download Operation & user’s manual of Casio 1517 Watch for Free or View it Online on All-Guides.com.

Brand: Casio

Category: Watch

Type: Operation & user’s manual for Casio 1517

Pages: 9 (0.53 Mb)

Download Casio 1517 Operation & user’s manual

Casio 1517 Operation & user’s manual - Page 1
1
Casio 1517 Operation & user’s manual - Page 2
2
Casio 1517 Operation & user’s manual - Page 3
3
Casio 1517 Operation & user’s manual - Page 4
4
Casio 1517 Operation & user’s manual - Page 5
5
Casio 1517 Operation & user’s manual - Page 6
6
Casio 1517 Operation & user’s manual - Page 7
7
Casio 1517 Operation & user’s manual - Page 8
8
Casio 1517 Operation & user’s manual - Page 9
9
1571-1
Module No. 1571
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
P
˚C
mb
hPa
P
A
B
D
C
L
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
P
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
A
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
˚C
m
A
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
km
STEP
Press C to change from mode to mode.
Hold down C for one or two seconds in any mode to switch back to the
Timekeeping Mode.
Timekeeping Mode
(Timekeeping)
Press D.
Trekking Counter Mode
GENERAL GUIDE
(Barometric Pressure/
Temperature)
Sensor
(Light)
Altimeter Mode
Recall Mode
World Time Mode
Alarm Mode
A
L
M
S
I
G
A
LT
I
RECALL
AUTO
MANUAL
A
L
A-LIGHT
P
A
D
C
L
A
B
D
C
L
A-LIGHT
Auto light switch on indicator
BACKLIGHT
The backlight uses an EL (electro-luminescent)
panel that causes the entire display to glow for
easy reading in the dark. The watch’s auto light
switch automatically turns on the backlight
when you angle the watch towards your face.
The auto light switch must be turned on
(indicated by the auto light switch on
indicator) for it to operate.
Note
The electro-luminescent panel loses
illuminating power after very long use.
The illumination provided by the backlight may be hard to see when viewed
under direct sunlight.
The watch will emit an audible sound whenever the display is illuminated.
This is caused by a transformer that vibrates when the EL panel lights up. It
does not indicate malfunction of the watch.
The backlight automatically turns off whenever an alarm sounds.
To manually turn on the backlight
In any mode, press L to illuminate the display for about two seconds.
The above operation turns on the backlight regardless of the current auto
light switch setting.
About the Auto Light Switch
Turning on the auto light switch causes the backlight to turn on whenever you
position your wrist as described below.
Avoid wearing the watch on the inside of your wrist. Doing so causes the
auto light switch to operate when it is not needed, which shortens battery
life.
Moving the watch to a position that is parallel to the ground and then tilting
it towards you more than 40 degrees causes the backlight to light.
The backlight turns off in about two seconds, even if you keep the watch
pointed towards your face.
The backlight may not light if the face of the watch is more than 15 degrees
off the parallel as shown below. Make sure that the back of your hand is
parallel to the ground.
Static electricity or magnetic force can interfere with proper operation of the
auto light switch. If the backlight does not light, try moving the watch back to
the starting position (parallel with the ground) and then tilt it back toward
you again. If this does not work, drop your arm all the way down so it hangs
at your side, and then bring it back up again.
Under certain conditions the backlight may not light until about one second
or less after turn the face of the watch towards you. This does not
necessarily indicate malfunction of the backlight.
Parallel to
ground
More
than
40°
More than 15 degrees
too high
More than 15 degrees
too low
Parallel to ground