User Manual 9050/9050plus
78413010-003 41
Printer Setups
The main printer setup parameters can be selected via the operator panel. The setup parameters are divided into two
printer setups, the Power-On Configuration, that allows a complete configuration at installation time according to the
hardware and the emulation types, and the Program Setup, that allows you to set the functions that are the most
useful in your daily job. These settings can be selected when the printer is online without printing or offline (
ON
LINE
indicator unlit) and stored in the NVM.
Entering the Printer Setups
Press the
PROGRAM
key and keep it pressed at the printer power on until the RELEASE KEYS
message is displayed to select the Power-On Configuration.
Press the
PROGRAM
key when the printer is online without printing or offline (
ON
LINE
indicator
unlit) to select the Program Setup.
Moving within the Printer Setups
The arrow keys ↑, ↓,
←
,
→
are used to move within the different functions inside the Printer Setups. See
the following description of the setup items.
Leaving the Printer Setups
Pressing the
PROGRAM
key in the Power-On Configuration the printer exits from the setup and the new
settings will be automatically saved.
Pressing the
PROGRAM
key in the Program Setup, the following choice is offered for the storage of the values
set:
STORE?
QUIT
The new settings are not activated and the old settings remain valid.
STORE?
SAVE
The new settings are stored permanently in the NVM (Non Volatile Memory).
STORE?
CURRENT
The new settings remain valid until the printer is turned off.
Press the
→
or
←
keys to scan these selections forward and backwards. When the desired setting is
displayed, press the
PROGRAM
key to exit from the Setup.
Printer Setup Item
When the Program Setup is run, these are the available ITEM :.
PRINT OUT? NO Print Program Setup
then
PRINT STATS? NO Print Statistics
then
USER MACRO Enter in the Macro Setup
then
CONFIG MENU NO Enter in the Power-on Configuration
then
HEX DUMP NO Enter in Hex Dump mode
then
STORE? QUIT Leaving Setup