HP Elite x3 Maintenance And Service Manual
Download Maintenance and service manual of HP ELITE X3 Cell Phone, Laptop for Free or View it Online on All-Guides.com.
Brand: HP
Category: Cell Phone , Laptop
Type: Maintenance and service manual for HP ELITE X3
Pages: 47
a. Remove the device side of the protective lm from the display pressure-sensitive adhesive.
b. With the removed adhesive side up, insert the display pressure-sensitive adhesive into the display
panel adhesive alignment xture.
NOTE: Make sure the device is oriented to match the display pressure-sensitive adhesive
orientation.
c. Place the device with the chassis side face down into the display panel adhesive alignment xture
to attach the display pressure-sensitive adhesive to the device.
NOTE: The device back cover will be facing up.
d. Hold the device in place on the adhesive with 240±10 N (24.5±1 kg) for 20 seconds.
e. Remove the device from the display panel adhesive alignment xture, and then verify the display
pressure-sensitive adhesive is located properly.
f. Use a plastic spudger to press the display pressure-sensitive adhesive along all four sides.
g. Remove the display side of the protective lm from the display pressure-sensitive adhesive.
h. Clean the camera area with 70 percent isopropyl alcohol or compressed air.
3. Apply the glue.
a. Secure the device, chassis-side up, in the glue machine xture.
b. Clean the glue machine nozzle with a lint- and static-free cloth and 70 percent isopropyl alcohol.
c. Run the glue program.
d. Visually inspect the glue path.
4. Install the display, and then reconnect the cables and brackets.
IMPORTANT: Be sure the display panel is completely clean. Remove any dust with compressed air or
with a lint- and static-free cloth and alcohol.
a. Secure the device, chassis-side up, in the display kit alignment xture.
b. Place the display side of the display assembly against the wall of the display kit alignment xture.
c. Connect the 60 pin display ex connector (1).
d. Replace the display ex retention bracket (2) and rescrew the two M1_L1.4 Phillips screws (3)
securing the bracket to the top right of the device.
e. Connect the battery ex (4).
f. Replace the battery ex retention bracket (5) and rescrew the two M1.6_L4.35 Phillips screws (6)
securing the bracket to the device.
Display panel assembly 23