• Home
• Brands
• Casio Manuals
• Casio E-Con EA-200
• Casio EA-200 User's Manual

Casio EA-200 User's Manual

Download Operation & user’s manual of Casio E-Con EA-200 Calculator, Power Supply for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

42

43

44

45

46

47

48

49

50

51

52

53

54

55

20020601

English

1-3

Using Commands

Basically, the EA-200 is controlled by commands from the connected calculator. This section

explains how to send commands from the calculator to the EA-200.

To use a command, you store parameters as List data on the calculator, and then use the

Send command to send the parameters to the EA-200.

EA-200 Operation

The following is an outline of the EA-200 command receive process.

1 Slide the EA-200 [ON/OFF] switch to turn on power.

2 EA-200 receives Command 0 sent from the calculator.

• This initializes the EA-200 setup.

3 EA-200 receives Command 1 sent from the calculator.

• This configures EA-200 channel settings.

4 EA-200 receives Command 3 sent from the calculator.

• This configures EA-200 sampling conditions.

• After sampling conditions are configured, the EA-200 enters the ready state.

5 Press the EA-200 [START/STOP] key.

• This puts the EA-200 into sampling mode.

• Sampling ends in accordance with the sampling conditions configured in step 4.

6 Sample data is sent from the EA-200 to the calculator in response to a Receive

command.

Sending a Command

Example 1: To initialize the EA-200 setup

{0} → List 1

__

__

_ Stores {0} to List 1. 0 is the command number.

Send (List 1)

__

__

_ Sending List 1 executes Command 0.

Example 2: To configure channel settings

{1, 1, 2} → List 1

__

__

_ Stores {1,1,2} to List 1. The first 1 is the command number, the

second 1 is the channel number, and the 2 indicates use of the

voltage probe.

Send (List 1)

__

__

_ Sending List 1 executes Command 1.

Receive Data Command

As with command execution, all of the operations required to receive data from the EA-200

to the calculator are performed on the calculator.

You can transfer sampled data by executing the calculator's Receive command.

Data is transferred in the sequence shown below.

Record Time → CH1 → CH2 → CH3 → SONIC

Receive (List 1)

__

__

_ Stores transferred data into List 1 of the calculator.

Using the Voltage Probe, Temperature

Probe, Optical Probe, and Motion Sensor

(EA-2)

The following examples show how to use the temperature probe, voltage probe, optical

probe, and “Motion Sensor (EA-2)”. Perform the procedures in each example by creating

programs on the calculator.

 Taking 60 samples at one-second intervals over one minute

(1) Send Command 0 to initialize the EA-200 setup.

{0} → List 1

__

__

_ Stores {0} to List 1. 0 is the command number.

Send (List 1)

__

__

_ Sending List 1 executes Command 0.