Juniper EX9214 Hardware Manual
Download Hardware manual of Juniper EX9214 Network Router, Switch for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Network Router , Switch
Type: Hardware manual for Juniper EX9214
Pages: 372
CHAPTER 13
Connecting the Switch to the Network
•
Connecting an EX9200 Switch to a Network for Out-of-Band Management on page165
•
Connecting an EX9200 Switch to a Management Console or an Auxiliary
Device on page 166
•
Connecting the EX9200 Switch to an External Alarm-Reporting Device on page 167
•
Connecting the Alarm Relay Wiresto the Craft Interface in an EX9200 Switch on page 168
•
Connecting a Fiber-Optic Cable on page 169
Connecting an EX9200 Switch to a Network for Out-of-Band Management
You can monitor and manage an EX9200 switch by using a dedicated management
channel. Each switch has an Ethernet management port labeled <...> with an RJ-45
connector for out-of-band management. Use the Ethernet management port to connect
the EX9200 switch to the management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the switch. Figure 52 on page 165 shows the RJ-45 connector of
the Ethernet cable supplied with the switch.
Figure 52: Ethernet Cable Connector
To connect a switch to a network for out-of-band management:
1. Turn off the power to the management device.
2. Connect one end of the Ethernet cable to the management port (labeled <...>) on
the Routing Engine module (RE module) installed in the switch.
For the location of the Ethernet management port, see Figure 53 on page 166.
3. Connect the other end of the Ethernet cable to the management device.
165Copyright © 2017, Juniper Networks, Inc.