Juniper EX9214 Hardware Manual
Download Hardware manual of Juniper EX9214 Network Router, Switch for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Network Router , Switch
Type: Hardware manual for Juniper EX9214
Pages: 372
Switch, Connecting DC Power to an EX9208 Switch, or “Connecting DC Power to an
EX9214 Switch” on page 158.
10. Verify that the BREAKER ON LED glows steady green.
11. Verify that the PWR OK LED glows steady green, indicating the power supply is correctly
installed and functioning normally.
If the power supply is not functioning normally, repeat the installation and cabling
procedures.
NOTE: After powering off a power supply, wait for at least 60 seconds
before turning it back on. After powering on a power supply, wait for at
least 60 seconds before turning it off.
If the system is completely powered off when you power on the power
supply, the Routing Engine boots as the powersupply completesits startup
sequence. If the Routing Engine finishes booting and you need to power
off the system again, first issue the CLI request system halt command.
After a power supply is powered on, it can take up to 60 seconds for status
indicators—such as the status LEDs on the power supply and the
show chassis command display—to indicate that the power supply is
functioning normally. Ignore error indicators that appear during the first
60 seconds.
12. On the external management device connected to the Routing Engine, monitor the
startup process to verify that the system has booted properly.
Related
Documentation
• Installing a DC Power Supply in an EX9204 Switch
• Installing a DC Power Supply in an EX9208 Switch
• Installing a DC Power Supply in an EX9214 Switch on page 193
Copyright © 2017, Juniper Networks, Inc.164
EX9214 Switch Hardware Guide