Whirlpool CHW9050 Service Manual
Download Service manual of Whirlpool CHW9050 Washer for Free or View it Online on All-Guides.com.
Brand: Whirlpool
Category: Washer
Type: Service manual
Model: Whirlpool CHW9050 , Whirlpool CHW9060
Pages: 116
4-40
NOTE: To avoid damage to components in
the cabinet base or on the outer tub, do not
let the outer tub drop free inside the cabinet.
19. Lift the outer tub straight up to separate
the air gap dampers then move it forward
out of the cabinet.
20. If replacing the outer tub, remove the
six flat nuts that secure the weights to the
tub. Pry them out of their slots with a flat
blade screwdriver. Flat nuts are usually not
supplied with a replacement tub.
NOTE: To install the flat nuts, insert a nut
into each slot and tap them into place.
21. Mark the outer tub where the clamp is
attached with the pressure hose tied to it.
14. Remove the vent tube (See page 4-35).
15. Remove three 1/2” bolts that secure the
lower front weight to the outer tub, and
remove the weight.
16. Remove three 1/2” bolts that secure
the top back weight to the outer tub, and
remove the weight.
17. Remove three 1/2” bolts that secure the
upper front weight to the outer tub, and
remove the weight.
NOTE: When reinstalling the bolts for the
weights make sure they are secured to
between 14 and 16 foot pounds of torque.
18. Lift the tub assembly to disengage the
suspension springs from the side panels.
Tub Spring:
One At Each Side