Whirlpool CHW9050 Service Manual
Download Service manual of Whirlpool CHW9050 Washer for Free or View it Online on All-Guides.com.
Brand: Whirlpool
Category: Washer
Type: Service manual
Model: Whirlpool CHW9050 , Whirlpool CHW9060
Pages: 116
4-3
6. Pull the control panel cover, facia and
display lens off the washer.
7. Depress the clips at the edges of the display
lens on the back side of the control panel
cover. Remove the snap-in lens from the
front of the control panel cover.
NOTE: To avoid damage, lay a towel, or
another covering, on the washer top and
place removed hardware and tools on the
covering.
8. The facia is secured to the control panel
cover with double stick tape. Press the
back of the facia, away from the control
panel cover, to release the tape.
9. Use a flat blade screwdriver, if necessary,
to pry the facia away from the control panel
cover.
NOTE: Make sure not to bend the facia in
the process
TECH TIPS:
n Machine screws must be used for the facia,
not sheet metal screws.
n There is a wire harness in the card reader
opening that is connected to the edge of the
UIC used in the manufacturing process only.
It can be left in the control panel or removed
if desired.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the control panel cover
(See page 4-2).
4. Remove two 1/4” hex head screws, one
in each top front corner behind the control
panel cover.
5. Lift the front edge of the washer top to open
it. When it is open all the way it will rest
on the 2 retaining supports attached to the
back of the washer just below the top.
NOTE: If the washer is not level the top may
not be stable enough to leave in the upright
position without using a support rod.
6. The top has 2 hinges, secured with Phillips
screws, that are hidden once the top is
closed.
WASHER TOP - OPEN
Two 1/4”
Hex Head
Screws
Support Rod