OpenEye CM-306 Rev B Installation/configuration

Download Installation/configuration of OpenEye CM-306 Rev B Security Camera for Free or View it Online on All-Guides.com.

Brand: OpenEye

Category: Security Camera

Type: Installation/configuration for OpenEye CM-306 Rev B

Pages: 2

Download OpenEye CM-306 Rev B Installation/configuration

OpenEye CM-306 Rev B Installation/configuration - Page 1
1
OpenEye CM-306 Rev B Installation/configuration - Page 2
2
Please carefully read these instructions before using this product.
Save this document for future use.
30832AC
model no: CM-306 Rev B
High Resolution Indoor
Dome Camera
Camera Installation & Conguration
Regulatory Compliance
General Specications Camera Overview Camera OSD Menu
Hardware Kit Contents
Camera Adjustments
Adjusting the Camera
Emissions FCC part 15 Class B
CE: EN55011
ICES-003
EN55022
CISPR 11
CISPR22
ANSI C63.4
Immunity CE: EN50130-4
FCC COMPLIANCE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in as
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try \to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced Radio/TV technician for help.
CISPR 22 WARNING:
This is a Class B product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
POWER SUPPLY REQUIREMENTS:
For use with listed Audio/Video product and only connected to 15W or less power supply.
*Power supply should be a NEC Class 2 / LPS Supply.
EQUIPMENT MODIFICATION CAUTION:
Equipment changes or modications not expressly approved by the manufacturer, the party responsible for FCC
compliance, could void the user’s authority to operate the equipment and could create a hazardous condition.
This class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Wall anchors (x4)
T3 1/4 screws (x4)
Rubber washers (x4)
Rubber caps (x4)
¾” threaded cable entry sealing plug (½” sealing plug tted to enclosure)
½” cable entry grommets (¾” grommet tted to enclosure)
External OSD service board
Torx Driver
Wire-Ended Power Adapter Lead
The following illustration shows the external service board which allows you to control
the On Screen Display (OSD) and make any programming changes required.
With the exception of the Focus (A) and Field of View (B) controls on the camera, all
settings are made using the keys on the OSD Service Board. When making adjust-
ments using the OSD Service Board, the camera must have power and be connected
to a video display.
1. Press ENTER to access the top level menu.
2. Use the arrow keys on the service board to navigate the OSD menu and use the
ENTER key to conrm your selections.
3. When you have completed the camera conguration, you must select EXIT to
save your changes.
4. If necessary, you can reset the camera to the factory default settings by selecting
RESET in the OSD menu.
A: Focus adjuster
B: Field of view adjuster
C: Service board connector
D: Service jack
Model No. CM-306 Rev B
Image Sensor 1/3” Sony CCD
Imaging DSP Sony Efo-E 2
IP Rating IP66
Type / Format NTSC
Wide Dynamic Range Yes, Digital Wide Dynamic Range
Minimum Illumination 0.3 Lux @ 50 IRE, 0.15 Lux @ 30 IRE
Day / Night Digital Day / Night
Resolution 700 TVL
Service Monitor Jack Yes
S/N Ratio >50dB
Focal Length 3.3 ~ 12 mm
Iris Control Auto
Synchronization Internal
Video Output 1.0Vpp 75Ω BNC Unbalanced
White Balance ATW, Manual, Push, Push Lock, User, Anti CR
Auto White Balance Range 2700K ~ 9700K
Backlight Compensation Full Range
Auto Gain Control 44.8 dB
Operating Temperature 14˚ ~ 122˚ F (-10˚ ~ 50˚C)
Heater Yes
Power Consumption 12W
Rated Amperage 0.5 A (24vAC)
Input Voltage 12vDC / 24vAC (± 10%)
Weight 1.12 lbs (0.51 kg)
Dimensions ø5.35” (136 mm) x H: 3.7” (94.2 mm)
Housing / Dome Cover White / Clear
23221 E Knox Ave
Liberty Lake, WA 99019
1.888.542.1103
www.openeye.net
A
B
Precautions
Do not attempt to dismantle the camera module mounted within the dome. There
are no user serviceable parts in the camera module. Refer servicing to a qualied
professional.
Handle the camera with care. Do not abuse the camera. Avoid striking or shaking
it. Improper handling and storage could damage the camera.
Do not operate the camera beyond its temperature or power source rating. Refer to
the environmental information provided in this document.
Emissions
FCC COMPLIANCE: This equipment complies with Part 15 of the FCC rules for
intentional radiators and Class B digital devices when installed and used in ac-
cordance with the instruction manual. Following these rules provides reasonable
protection against harmful interference from equipment operated in a commercial
area. This equipment should not be installed in a residential area as it can radiate
radio frequency energy that could interfere with radio communications, a situation
the user would have to x at their own expense.
UP
Down
Lens Manual Auto Iris Type DC / Video
Auto Mode Open / Close / Auto
Speed 0 ~ 255
Shutter / AGC Manual Manual
Setup
Mode Shut + AGC
Shutter 1/50 (1/60*), 1/100 (1/120*), 1/250
1/500, 1/1000, 1/2000, 1/4000,
1/10000
AGC 6.00, 12.00, 18.00, 24.00, 30.00,
36.00, 42.00, 44.80
Auto Auto Setup Mode Shut + Auto Iris / Auto Iris
High
Luminance
Brightness 0 ~ 255
Low
Luminance
Mode Off / AGC
Brightness X0,25 / X0.5 / X0.75 / X1.0
White Bal. ATW ATW Speed 0 ~ 255
Delay Cnt 0~ 255
ATW Frame X0.5 / X1.0 / X1.5 / X2/0
Environment Indoor / Outdoor
Push B-Gain 0 ~ 255
User 1/2 User 1/2
WB
R-Gain 0 ~ 255
Anti CR
Manual Manual WB Level 0 ~ 255
Push Lock
Backlight Off / BLC / HLC Mirror Off / On
Pict Adjust Pict Adjust Brightness 0 ~ 255
Contrast 0 ~ 255
Sharpness 0 ~ 255
Hue 0 ~ 255
Gain 0 ~ 255
ATR Off Luminance Low / Md / High
On ATR Contrast Low / Mdlow / Md / Mdhigh / High
Motion Det On Motion Det Detect Sense 0 ~ 127
Off Block Disp Off / On / Enable
Monitor Area Off / On
Area Sel 1/4 ~ 4/4
Top 0 ~ 244
Bottom 0 ~ 244
Left 0 ~ 474
Right 0 ~ 474
Privacy On Privacy Area Sel 1/4 ~ 4/4 (1/8 ~ 8/8**)
Off Top 0 ~ 244
Bottom 0 ~ 244
Left 0 ~ 474
Right 0 ~ 474
Color 1 ~ 8
Transp 0.00 / 0.50 / 0.75 / 1.00
Mosaic Off / On
Day / Night Auto Day / Night Burst Off / On
Delay Cnt 0 ~ 255
Day - Night 0 ~ 255
Night - Day 0 ~ 255
Color
B/W B/W Burst Off / On
IR Optimizer Off / On
Mode Auto / Center
Level 0 ~ 31
NR NR NR Mode Off / Y / C / Y/C
Y Level 0 ~ 15
Camera ID Off / On C Level 0 ~ 15
Sync Int
Language English / Chinese / Spanish / Portuguese / Russian / French / German / Japanese
Camera Reset
Exit
Next
Back
Save All