Cisco HPNA Quick Reference Manual

Download Quick reference manual of Cisco HPNA Control Unit for Free or View it Online on All-Guides.com.

Brand: Cisco

Category: Control Unit

Type: Quick reference manual for Cisco HPNA

Pages: 2

Download Cisco HPNA Quick reference manual

Cisco HPNA Quick reference manual - Page 1
1
Cisco HPNA Quick reference manual - Page 2
2
HPNA Module
for DigiStar Ethernet over Coax Aggregation Point (AP)
Introduction
This installation quick reference is intended for individuals responsible for installing the
HPNA module for the DigiStar Ethernet over Coax Aggregation Point (AP). For complete
information about Safety Instructions, Installation and Operation, see the DigiStar Ethernet
over Coax (EoC) Aggregation Point (AP) E230 Installation and Operation Guide, part
number 4040978.
NOTE
Power off the AP before removing or installing the HPNA module. Hot swapping the
HPNA module may damage the AP and HPNA module.
Do not force the HPNA module connector into the main board connector. It may damage
the connectors on the HPNA module and the main board.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the
U.S. and other countries. A listing of Cisco's trademarks can be found at
www.cisco.com/go/trademarks.
Third party trademarks mentioned are the property of their respective owners. The use of the word
partner does not imply a partnership relationship between Cisco and any other company. (1009R)
Specifications and product availability are subject to change without notice.
2011 Cisco and/or its affiliates. All rights reserved.
Cisco Systems Inc.
800 722-2009 or 678 277-1120 Part Number 4042738 Rev A Number 7019941 Rev A
www.cisco.com October 2011 February 2010
HPNA Module Installation
Module 1 Installation
Follow the instructions below to install HPNA
module 1.
1. Power off the AP.
2. Place module 1 in a vertical position and
align its Front Surface with Edge A of the
white cover as shown on the right.
3. Insert the two module screws into the
screw holes and the single guide hole.
4. Gently adjust the module to align and
guide the module connector into the
main board connector.
5. Gently press module 1 and confirm that
the module connector is inserted
completely into the main board
connector.
6. Do not force the module connector into
the main board connector. Repeat steps
4-5 if you find it difficult to insert the
module connector into the main board
connector.
7. Tighten the two module screws with a
flat tip driver from 0.39 Nm to 0.98 Nm.
Module 2 Installation
Follow the instructions below to install HPNA
module 2.
1. Power off the AP.
2. Place module 2 in a vertical position and
align its Back Surface with Edge B of the
white cover as shown below.
3. Insert the two module screws into the
screw holes.
4. Gently adjust the module to align and
guide the module connector into the
main board connector.
5. Gently press module 2 and confirm that
the module connector is inserted
completely into the main board
connector.
6. Do not force the module connector into
the main board connector. Repeat steps
4-5 if you find it difficult to insert the
module connector into the main board
connector.
7. Tighten the two module screws with a
flat tip driver from 0.39 Nm to 0.98 Nm.
Module 1 Installation
Module 2 Installation
Quick Reference Guide