Andrews PAC14 Series 5 QC Operating Instructions & Safety Manual

Download Operating instructions & safety manual of andrews PAC14 Series 5 QC Air Conditioner for Free or View it Online on All-Guides.com.

Brand: andrews

Category: Air Conditioner

Type: Operating instructions & safety manual for andrews PAC14 Series 5 QC

Pages: 2

Download andrews PAC14 Series 5 QC Operating instructions & safety manual

andrews PAC14 Series 5 QC Operating instructions  & safety manual - Page 1
1
andrews PAC14 Series 5 QC Operating instructions  & safety manual - Page 2
2
PAC 14 Series 5 QC
Air conditioning
Operating Instructions
& Safety Guide
General Safety
Electrical Safety
This equipment should only be used by a competent person
who has read and understood these instructions
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately
Never operate this equipment if you are ill, feeling tired or
under the influence of alcohol or drugs
Keep all vents and grilles clear of obstructions
Keep children and animals away from air conditioning
units
Never leave them alone in room where the units in use.
Make sure equipment is switched off and unplugged after
use.
This unit requires a 230 volt electrical supply. It plugs
into standard domestic BS1363 13 amp socket
Always inspect plugs and power cables for damage before
plugging into power supply
DO NOT USE IF ANY DAMAGE IS
FOUND
Ensure cables are installed so as not to cause a hazard
If an extension lead is used, ensure it is of the correct
standard and fully uncoiled before use
Cables must not be laid in wet or damp areas
Do not move equipment while operating
Do not pull equipment by the power lead
It is recommended that this equipment is protected by an
RCD when in use.
Getting started and operation
The unit consists of the indoor cooling unit and an
external heat exchange unit. The external heat
exchanger must be positioned outside the area to be
cooled, either by hanging the external unit out of a
widow (fig1) or for more permanent/ long term
applications, disconnecting the refrigerant flexible
lines from the room unit and passing through a
100mm diameter hole in the wall and reconnecting.
Always use 2 spanners to avoid damaging the
copper pipework. (fig2).
Fig
1