NETGEAR AC750 JR6150 Installation Manual
Download Installation manual of NETGEAR AC750 JR6150 Wireless Router for Free or View it Online on All-Guides.com.
Brand: NETGEAR
Category: Wireless Router
Type: Installation manual for NETGEAR AC750 JR6150
Pages: 2
1
2
Installation Guide
AC750 Wireless Dual Band Gigabit Router JR6150
Package Contents
Step 1. Step 2. Step 3.
Step 4. Step 5. Step 6.
Unplug the power
to turn off your modem.
Connect one end of the blue
Ethernet cable to your modem,
and the other end to the Internet
port on your router.
Plug in, then turn on your modem.
Connect the power adapter to the
router, then plug it into an outlet.
Wait until the Wireless LED turns
solid green.
Connect the router
to your computer.
Open a browser.
Power adapter Ethernet cable
AC750 Wireless Dual Band Gigabit Router
Internet
DSL
or Cable
Modem
AC750 Wireless Dual
Band Gigabit Router
(not included)
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your modem to power.
If none of the LEDs light, make sure that the
Power On/Off button is in the on position
(pushed in).
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
(Optionally) Connect wirelessly by using the
preset wireless security settings located
on the bottom label.
If the web page does not display,
close and reopen the browser and
enter http://www.routerlogin.net
in the address bar, or check the
“Troubleshooting” chapter of the
user manual.
Power
On/Off