Avery Weigh-Tronix TM-295 User Manual

Download Operation & user’s manual of Avery Weigh-Tronix TM-295 Printer for Free or View it Online on All-Guides.com.

Avery Weigh-Tronix TM-295 Operation & user’s manual - Page 1
1
Avery Weigh-Tronix TM-295 Operation & user’s manual - Page 2
2
1. An ON/OFF power switch is recessed on the left side. The 24 Vdc
power source is connected via a spring-loaded interlocking connector.
The RS-232 serial interface cable attaches to a female 25-pin connector
on the rear of the printer. The control panel has three operator keys and
three lighted indicators. The lights indicate when power is applied, paper
is present, and if the paper is released for removal. The buttons allow
for forward feeding, reverse feeding, and the release of the paper
2. The print surface has an open throat design allowing paper to be
inserted from three directions.
3. The TM-295 uses a ribbon ink cartridge. Slide the cover to the left and
swing it towards you for access.
4. SELF TEST
a) Apply power to the printer and press the RELEASE key.
b) Insert a piece of paper
c) Turn off the printer
d) Hold down the RELEASE key and turn the power back on.
e) Remove your finger from the RELEASE key. The printer will
provide its current serial interface configuration settings. Press
RELEASE to allow for paper removal, and observe the print out.
f) Inserting a new piece of paper allows the printer to produce a test
pattern and print “completed” when finished. (More than one piece
of paper will be required.)
5. Programming switches are located on the bottom of the printer. These
switches allow the printer serial interface selections to be configured.
(The current settings were printed during the self-test.) Defaults are
shown in bold in the following table.
Operation
TM-295 Printer Users Guide
SW Function ON OFF 1200 2400 4800 9600
1 Data reception error Ignored Prints “?”
2 receiver buffer capacity 35 bytes 512 bytes
3 Handshaking XON/XOFF DTR/CSR
4 Word length 7 bits 8 bits
5 Parity check Yes No
6 Parity selection Even Odd
7 BAUD RATE - - ON OFF ON OFF
8 BAUD RATE - - ON ON OFF OFF
9 Pin 6 reset signal Not used Not used
10 Pin 25 reset signal Not used Not used