Maytag AMV6177AAB Service Manual
Download Service manual of Maytag AMV6177AAB Microwave Oven for Free or View it Online on All-Guides.com. This version of Maytag AMV6177AAB Manual compatible with such list of devices, as: AMV6177AAB, AMV6177AAQ, MMV6178AAB, MMV6178AAQ, MMV6178AAS
Brand: Maytag
Category: Microwave Oven
Type: Service manual
Model: Maytag AMV6177AAB , Maytag AMV6177AAQ , Maytag AMV6177AAS , Maytag AMV6177AAW , Maytag MMV6178AAB , Maytag MMV6178AAQ , Maytag MMV6178AAS , Maytag MMV6178AAW
Pages: 47
Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.
24 16023057 Rev. 0 ©2004 Maytag Services
WARNING
!
Control Key Panel
The key panel has one ribbon connection on the p.c.
board.
The key panel pads can be checked through a continuity
test. Operations of key pad can be checked by
measuring connections at end of ribbon, (using high
ohms scale).
Plastic
fastener
Holes
Hook
Terminal
socket
F.P.C.
connector
Control Key Panel Removal
1. Disconnect power to oven.
2. Remove control panel, (see "Control Panel" section).
3. Discharge high voltage capacitor, (see "High Voltage
capacitor section).
4. Disconnect ribbon connector by sliding top part of
connector upward. Once in released position remove
ribbon from connector by siding ribbon side-to-side.
NOTE: Caution should be used when removing cable
from connector. Ribbon cable has two holes
which connector locks ribbon in place.
5. Peel failed key pad off and replace with new key pad.
6. Reassemble in reverse order.
Outer Case
NOTE: This procedure requires removal of unit.
1. Disconnect power to oven and remove grille, (see
"Grille" procedure).
2. Remove oven door (see "Door Removal" procedure).
3. Remove screws securing air duct to outer case.
4. Remove screws securing outer case to the chassis.
5. Remove screws securing vent plate to outer case.
6. Remove screw securing power cord cover to outer
case and remove power cord cover (if equipped).
7. Slide outer case towards the rear of the unit, guide
power cord though outer case power cord hole.
8. Place outer case to the side, so no damage will
occur to the case.
9. Reassemble in reverse order.
Vent grille
Controller
Mounting
plate
Door
Outter case
Vent plate
Power cord cover
Stirrer Assembly
Motor driven antenna assembly is located at the top of
the cavity, using a top feed wave guide.
Stirrer Blade Removal
1. Disconnect power to oven and open the oven door.
2. Carefully pry downward on the plastic rivets securing
the stirrer cover.
3. Rotate slightly and pull down on stirrer fan cover .
4. Reassemble in reverse order.