Maytag MDG-50 Installation Manual
Download Installation manual of Maytag MDG-50 Dryer, Furnace for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
30
NOTES: 1. If the anti-wrinkle program is active, the light emitting diode (L.E.D.) display will continue
to read "donE," and the microprocessor controller (computer) will proceed through the
anti-wrinkle program until the maximum "Active Guard Time" has expired or until the door
is opened, whichever comes first. The L.E.D. display will read "FILL" or "Amount To
Start."
2. If the anti-wrinkle program is not active or in use, the L.E.D. display will read "FILL" or
"Amount to Start."
2. Timed Mode (Microprocessor Controller [Computer] Models)
a. When turning on power or when no cycle is in progress, the L.E.D. display will read "FILL" or "Amount
To Start."
b. Insert Coins.
Once the correct "Amount To Start" has been inserted, the L.E.D. display will read "PUSH."
c. Select temperature by pushing "HI TEMP," "LO TEMP," or "PERM PRESS." The dryer will start and
the L.E.D. display will read the temperature cycle selected and the drying time.
d. The dryer will continue through the drying and cooling cycles, showing time counting downward.
IMPORTANT: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count downward in time.
Continuation of the cycle will resume only after the door has been closed and any
other of the three (3) temperature selection buttons is again depressed.
e. Upon completion of drying and cooling cycles, the tone (buzzer) will sound for 5-seconds, and the
L.E.D. display will read "donE," at which time the dryer will shut off.
NOTES: 1. If the anti-wrinkle program is active, the L.E.D. display will continue to read "donE", and
the microprocessor controller (computer) will proceed through the anti-wrinkle program
until the maximum "Active Guard Time" has expired or until the door is opened, whichever
comes first. The L.E.D. display will read "FILL" or "Amount To Start."
2. If the anti-wrinkle program is not active or in use, the L.E.D. display will read "FILL" or
"Amount To Start."
3. Free Dry Mode (Microprocessor Controller [Computer] Models)
a. When turning on power or when no cycle is in progress, the L.E.D. display will read "FILL" or "FrEE."