GE JCSP38DN4WW Installation Instructions

Download Installation instructions of GE JCSP38BK1BB Cooktop for Free or View it Online on All-Guides.com. This version of GE JCSP38BK1BB Manual compatible with such list of devices, as: JCSP38DN4BB, JCSP42DN3BB, JCSP46DP2WW, PCS905SP2SS, PCS968DP2WW

GE JCSP38BK1BB Installation instructions - Page 1
1
GE JCSP38BK1BB Installation instructions - Page 2
2
GE JCSP38BK1BB Installation instructions - Page 3
3
GE JCSP38BK1BB Installation instructions - Page 4
4
Installation Instructions
30" Electric Slide-In Ranges
Questions? Call 1.800.561.3344or visitwww.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT--save these instructionsfor localinspector'suse.
IMPORTANT---Observe all governing codes and ordinances.
Note to Installer - Be sure to leave these instructionswith Consumer,
Note to Consumer - Keep these instructionsfor future reference.
° Skill level - Installationof this appliance requires basic mechanical
skills and advanced electrical skills,
Proper installation is the responsibilityof the installer.
Productfailure dueto improperinstallationis not covered underwarranty.
AWARNING: Thisapp,,ancemustbeproperly
connected by means of the suppliedcord and plug. If yourkitchen does not
have a receptacle, you must have one installed by a licensed electrician.
FOR YOUR SAFETY:
_ Anti-Tip
Bracket Kit
Included
Ifyoudid not receivean anfl-tip
bracketwithyour purchase,
call 1,800.561.3344 to receive
one at no cost.For installation
instructionsof the bracket,
visitwww.GEAppliances.ce.
A WARNING---Before beginning the installation,switch
power off at servicepanel and lock the servicedisconnectingmeans to
prevent power from being switchedon accidentally.When the service
disconnectingmeans cannotbe locked, securelyfasten a prominent
warning device, such as a tag, to the servicepanel.
• All ranges can tip.
BURNS or other SERIOUS
INJURIES can result.
INSTALL and CHECK the
ANTI-TIP bracket following
the instructions supplied
with the bracket.
TOOLS YOU WILL NEED
Drill with 1/8" Bit Level
Safety Glasses Tape Measure
Adjustable Wrench
Pliers
1/4" Nut Driver
Ill REMOVE PACKAGING MATERIALS
Failure to remove packaging materials couldresult in damage to the
appliance. Remove all packingpartsfrom oven, racks,heating elements
and drawer.Also, remove protectivefilmand labels on the door, cooktop
(do not remove side protection on glass cooktops) and backguard.
Do not remove protectivechannelfrom sidesof glasscooktop,ifapplicable,
until later in installation.
NOTE: Cut the orangeshippingties from the powercord, being careful not
to damage the cord.
ALTERNATE INSTALLATION/
CONSTRUCTION KITS
Description:
Backguard_ Addsa decor-aWebackguardtotherearoftherange.Thiskitcanonly
be usedwhentheopeninginthecountertopis63.5 cm (25")deep,
MaintopRllerlot: Adds a fillershiptothe rearof the range.Thiskitcanonlybe used
when the openinginthe countertopis63.5cm (25")deep.This kitcannot be used
witha backguardt_.
BodySideW.,'t:Coffins a color-matd"_lsidepanelwhichcanbe usedtocreate
: a finishedappearanceoneithersideof the range.
LowerTrimKit:Containsa coler-m_ toekicka.ndextra-longlevelinglegs.
Designedto be usedwhen therangeneedsto beraisedhigherthan92.7crn (36-1/2").
To order accessory kits, call 1.800.661.1616, or visit www.GEAppliances.ca.
] 11-08 JR
31-10674
J
w
I"
I-_ PREPARE THE OPENING (FOR INDOORUSEONLY)
If the countertoparea is notflat,excess tension may be applied to the glass
cooktopcausing breakage and voidingthe warranty.Make surethe wall
covedng,countertop,floodng and cabinetsaroundthe rangecan withstand
the heat (up to 93°C [200°F]) generated bythe range.
A. Allow 76.2 cm (30") minimumclearancebetween surface unitsand bottom
of unprotectedwood or metal cabinet, orallow a 61 cm (24") minimum
when bottomofwood or metal cabinet is protectedby no lessthen 6.3 mm
(1/4") thick flame retardantmillboardcovered withno less than No. 28 MSG
sheet metal .38 mm (.015")thick, .38 mm (.015") thick stainlesssteel,
.63 mm (.025")aluminum or .5 mm (.020") copper.
B. A minimum15.2 cm (6") spacingto surfaces lessthan 38.2 cm (15")
abovethe ccoktop and adjacentcabinetryis recommended to reduce
exposureto steam, grease splatterand heat. Allow 6.3 mm (1/4")
minimumclearanceat the backwall.
To reduce the dskof bums orfire when reachingover hotsurfaceelements,
cabinet storage space above the cooktopshouldbe avoided. If cabinet
storagespace is to be providedabove the cooktop,the dsk can be reduced
by installinga range hoodthatprojectsat least12.7 cm (5") beyond the front
of the cabinets. Cabinets installedabove the cooktop must be no deeper
than 33 cm (13").
Front surface -_ 59.7 cm--61 cm 80 cm (31-1/2") - Metal cooktops
ofcountertop , __
I _ _ 1/ to cool(top
I "]_,e_,.= _'"_ 91.1 cm-92.7 orn
,I_,,L _ _ I j- (35-7/8"-36-1/2")
.. -T-,,_-___.Z,,-_p.j_-__ oR
, I__.,.;"11 _ 27_986o
, I ,"_.__'_._---_1_t _'_ M / (36-1/2"-38")
' I // _.'_"_'l _ / Ihlowertnm
,,' .l ," I. 1 ]IL/ (_step2)
,.. -
49.5,_=-_2.3_.><_I;_">.-_1
79.4 cm (31-1/4") - Glass cooktops
/
7.3 cm (2-7/8") --_
' 91.1 cm-92.7 orn
711// " 92.7 cm-96.5Cmwithlower trimkit
49.5 cm-52.3 orn_
Door clearance
from front surface
. of countertop
I" 79.1cm(31-1/8") ,1
CON to prevent inten_.mnce _h
the Storage drawer. Power cords
137 cm (4-1/2') to 182.2 orn (6')
longmay have to be dressed
to allow for proper drawer dosing. If the conb'ol panel measures 79.1 cm (31-1/8") as shown
above AND if the countertop has a raised edge, shave raised
edge to clear the control panel as shown below.
76.2 c[n /
_e°otell-(_°")_°--t *
08. =(2s-)
3.1=
(29-15/16"_o-1/1_')'-._1]_
O_ e_ed_cal recoptade so the leng_ isparallel to the flonr,
l
!
1.4_(_16_
f
6.3mm(1/4")TI
min. flat / I 63.5 cm (25")
(_zg_____ 1.4=1
(9/16")I
Smooth cut ._
76 crn-76.4 cm (29-15/16"-30-1/16"
Rat area
6,3 mm
91.4 crn (36")