INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUAUFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Do not pinch the power
supply cord between the
range and the wall
Do not seal the range to the
side cabinets_
* NOTE: 24" (61 cm)
minimum clearance
between the cooktop and
the bottom of the cabinet
when the bottom of wood
or metal cabinet is
protected by not Jess than
1/4" (0_64 cm) flame
retardant milJboard
covered with not less than
No 28 MSG sheet metal,
0015" (0.4 ram) stainless
steel, 0024" (0_6 ram)
aluminum, or 0.020" (05
ram) copper_
30" (762 cm) minimum
clearance when the
cabinet is unprotected
NOTE: For 29" (73,7 cm) cutout wide
opening, you must call the Service
Center for optional side panels and
clear wide cooktop rim as shown in
the "Countertop Preparation" section
(see page 5},
30" Min
I, (76,2 cm) Min,
!3"
(33 cm)
i
Shave Raised
Edge To Clear
31 1/2"(81cm) 1 Y2" Max
IWide Cooktop (3_8cm Max)
Rim,
18" Min
(45.7 cm) Min,
Locate Cabinet Doors
1 " (2.5 cm) Min.
From Cutout Opening
24" Min
(61 cm) Min.
Grounded Junction Box or Wall Outlet Should Be
Located 8" to 17" (20,3 - 432 cm) From Right
Cabinet and 2" to 4" (51-10.2 cm) From Floor
NOTE: Allow at least
19 ¼" (48.9 cm)
clearance for door
/
depth when it is /
/
open
314"
(55.25 cm)
Door Open
(seenote)
1 5/16"
.(3,3 cm)
A
22 718" **
(581 cm) rain,
For cutouts below
22 7/8"(58_1 cm),
appliance will
slightly show out
of the cabinet
--€
FRONT
OF
CABINET
IMPORTANT: For width cutout (F dimension) more
than 30 1116" (76,4 cm) to avoid glass breakage,
make sure the appliance is centered in the counter
opening while pushing into it. Raise leveling legs at
maximum position, insert the appliance in the counter
and then level, Make sure the unit is supported by
the leveling legs not by the smoothtop glass itself.
. . OF RANGE , . , COUNTERTOP
35 3/8" (90 cm) - 36 3/8" (92 cm} 30" (76,2 cm) 28 5/16" (71,9 cm) 30±1/16" 21 3/4" (55,2 cm) Min. 36" (91,4 cm) standard
(76,2±0,I5 cm) 22 1/8" (56,2 cm) Max 35 3/8" (90 cm} rnin
G. Minimum cutout depth is increased to 24" (61 cm) with backguard.
P/N 318201609 (0403) Rev A
English - pages 1-10
Espar_ol - pBginas 11-20
