Warning!
If the printer has recently been powered on, some
fuser components will be very hot. Handle the fuser
with extreme care, holding it only by its handle, which
will only be mildly warm to the touch. A warning
label clearly indicates the area. If in doubt, switch
the printer off and wait at least 10 minutes for the
fuser to cool before opening the printer cover.
1. Press the cover release and open the printer's top cover fully.
2. Pull the two blue fuser lock levers (1) towards the front of the printer.
3. Holding the fuser by its handle, lift the fuser out of the printer. If the fuser is still
warm, place it on a flat surface which will not be damaged by heat. After letting
the fuser cool down, discard it.
5. Push the orange transport lock (1) to the left to release it (SNAP!), then
remove the transport lock.
6. Holding the new fuser by the handle, with the fuser pressure release lever
(1) on the right, lower the fuser into the priner.
7. Push the two blue retaining levers (1) toward the rear of the printer to lock
the fuser in place.
8.Close and latch the top cover.
①
①
①
①
①
58368302
①
4. Remove the new fuser from its packaging, then remove any packing tape.
Fuser Replacement for Oki 42625501 & 42625502
C3200/5150/C5200/C5400 Printers
Fuser Instructions
