Acer HDS WMS100 Reference Manual
Download Reference manual of Acer HDS WMS100 Server for Free or View it Online on All-Guides.com.
Acer | HDS WMS100™ User and Reference Guide 209
8.4.5.3 Progress Messages
When the following Progress messages are displayed, follow the instructions to resolve the
problem.
Table 8.8 Progress Messages (continues on next page)
Message Code Message Text Recovery Measures
I031xy Path recovered automatically The path recovered automatically.
(x: Remote DF# (0), y: Path # (0 or 1))
I10000 Subsystem is ready The unit is ready.
I11000 All raid group initialized All RAID groups were deleted.
I111xx RAID group deleted (RG-xx) All LUs were deleted. (xx: RAID group# (0-14))
I12000 ALL LU initialized All LUs were deleted. (This is also displayed when the LU#0 is
created.)
I12100 LU deleted (LU-xxx) LUs were deleted. (xxx: LU# (0-511))
I12200 LU format completed (LU-xxx) LU formatting was completed. (xxx: LU# (0-511))
I12400 LU format start (LU-xxx) An LU formatting was started. (xxx: LU# (0-511))
I12500 Unified LUs separated (Uni: LU-xxx) Dissolution of all LU unification (to dissolve unification of all
the unified LUs and to split them into internal LUs) was
executed.
(xxx: LU# (0 to 511) of a unified LU to be split)
I12600 Last LU separated from unified LU
(Uni: LU-xxx)
A separation of a final LU of a unified LU (to separate the last
one of the internal LUs which have been combined with a
unified LU) was executed.
(xxx: LU# (0 to 511) of a unified LU to be split)
I12700 LU reappeared (Uni: LU-xxx) An internal LU(s) was validated again through splitting of all
unified LUs or a separation of a final LU.
(xxx: An LU# (0 to 511) of an internal LU which has been
separated and validated)
I15Axy Dynamic sparing start
(Unit-x, HDU-y) [zzzzzzzzzz]
Dynamic sparing started.
(x: Unit ID# (0-14), y: Disk drive# (RKXS=0-13, RKAJ=0-14),
z: Detailed code)
I17002 Default LU-CTL change failed [PS
OFF]
Set the equipment in the ready state and turn off the power,
then turn on the power again
I17003 Default LU-CTL change failed [HOT] Use the system as it is
I17004 Default LU-CTL change failed [LU]
Permanent LU
I1A00x Permanent LU disable
(Default CTL-x)
Set the equipment in the ready state and turn off the power,
then turn on the power again.
I1A10x Permanent LU deleted
(Default CTL-x)
LU residence is deleted. (When RAID group/LU is deleted)
(x: Default Controller# (0 or 1)
I1A30x Permanent LU enable
(Default CTL-x)
The FlashAccess function was turned on.
(x: Default Controller# (0 or 1))