Acer HDS WMS100 Reference Manual
Download Reference manual of Acer HDS WMS100 Server for Free or View it Online on All-Guides.com.
Acer | HDS WMS100™ User and Reference Guide 181
8.2.2 Characteristics of Network Functions
This section discusses the following network function characteristics:
LAN Interface
The connector for 10Base-T/100Base-TX is equipped with the controller. 10Base-
T/100Base-TX is selected automatically.
Network Parameter
The WMS100 has the following network parameters; they can be set or changed by the
Web browser or the Storage Navigator Modular, concerning only port 1 (for user
management) of each controller.
Table 8.3 Network Parameters
Factory Setting Value (see Note 1)
Controller 0 Controller 1
Network Parameter Description
For User-managed Port For User-managed Port
IP Address The IP Address is
changed/set up.
192.168.0.16
(see Note 1)
192.168.0.17
(see Note 1)
Subnet Mask The Subnet Mask is
changed/set up.
255.255.255.0
255.255.255.0
Default Gateway The Default Gateway is
changed/set up.
0.0.0.0 0.0.0.0
DHCP
(see Note 2)
Enable/Disable of the DHCP
function is set up.
Off Off
Note 1: Manage the IP Address after the IP Address is changed from the IP Address of factory
setting.
Note 2: When the DHCP mode is validated, the IP Address is acquired from the DHCP server.
If the DHCP server is not started up, or if the DHCP function has been wrongly set, the
acquisition of the IP Address will fail, and the IP Address of the subsystem will remain
0.0.0.0. (This is a state in which Storage Navigator Modular or the Web cannot be used via a
LAN.) You can acquire the IP Address by starting up the DHCP server or by setting the DHCP
function correctly, when necessary.