• Home
• Brands
• Maytag Manuals
• Maytag 11-06-00
• Maytag 11-06-00 Installation Instructions Manual

Maytag 11-06-00 Installation Instructions Manual

Download Installation instructions manual of Maytag 11-06-00 Microwave Oven, Oven for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

NOTES

Z Do not block air intake slots along bottom of oven.

INSTALLATION

1. Cut hole in cabinet to mount oven. Cutout in

cabinet should be level and straight.

NOTE: There are no provisions to level the unit

after it is installed. An oven that is not level could

cause poor baking results.

2. Install plywood floor as shown above.

3. Install top mounting bracket -- also refer to

template.(figure 3)

Top bracket mounting installation

instructions:

a. Before installing unit into the cabinet, open

microwave door, remove the two upper screws in

the trim kit holding the top mounting bracket (see

figure 1 next page) and set the bracket and

screws to the side.

b. Using scissors cut along the cut line on the

template (provided).

c. Find the center of the cabinet cutout.

d. Align the template ”center of opening” to the

center of the cabinet cutout making sure the top

of the cabinet cutout corresponds with the

template ”top of opening” indicator line. Tape may

be used to hold the template temporarily in place.

e. Locate and mark screw holes (A) at both

ends, 2 each side, of template.

f. Remove template and set it to the side.

g. Drill pilot holes into cabinet using 7/64” or

#35 drill bit.

h. Install top mount bracket (from step 3a) to

cabinet with the provided wood screws. (1/2” X 4)

8101P744-60

(11-06-00)

CAUTION

For European style cabinets (flush front) the required

clearance for operation of the oven door is minimum

spacing of 7/8″ between the cutout and the door, hinge

or drawer of the cabinet.

Some built-in cabinets may not be wide enough, due

to their construction, to allow this installation.

COMBINATION

WALLOVEN CUTOUT

30″ WALL OVEN DESCRIPTION

11-1/4″ Dia. Conduit Access Hole*

25/8″ Plywood Floor (Must Support 250 lbs.)

DIMENSIONS

in cm

A 30 MIN 76.20 MIN

B 24 MIN 60.96 MIN

C47+

1/16 119.38 + .16

D 24 MIN 60.96

E 28-1/2 +

1/16 72.39 + .16

F 47-5/8 120.97

G 29-3/4 75.57

H 24-7/16 62.07

I 4 to 20 10.2 to 50.8

* Hole must be cut as close to corner of cabinet as possible.

INSTALLATION

INSTRUCTIONS

Built-In 30″ Electric

Combination Wall Ovens

403 WEST FOURTH STREET, NORTH

NEWT ON, IA 50208

Top bracket mounting installation instructions:

(continued)

i. Install and push unit in until trim frame engages with top

mount bracket.

j. Drive two screws that were removed in step (a) Do not

over tighten the screws.

4. Attach unit to the cabinet with 4 No. 8, flat head screws

supplied inside of envelope containing these instructions.

Pre--drill holes in cabinet for attachment screws using 1/8,

drill. Oven mounting holes are provided in side trim.

5. See instructions ”Electrical Connections” for electrical

hook--up.

6. See figure 2 next page for lower trim installation.

7. See User’s Manual for operating instructions.