Maytag W10267633A Installation Instructions Manual

Download Installation instructions manual of Maytag Cabrio,- WED7300X Dryer for Free or View it Online on All-Guides.com. This version of Maytag Cabrio,- WED7300X Manual compatible with such list of devices, as: Cabrio,- WED7300X, Cabrio,- WED7800X, MGDB800VU - Bravos Steam Gas Dryer, W10267633A, WED6400SB - Cabrio 7.0 Cu Ft Capacity Electric Dryer

Maytag Cabrio,- WED7300X Installation instructions manual - Page 1
1
Maytag Cabrio,- WED7300X Installation instructions manual - Page 2
2
Maytag Cabrio,- WED7300X Installation instructions manual - Page 3
3
Maytag Cabrio,- WED7300X Installation instructions manual - Page 4
4
Maytag Cabrio,- WED7300X Installation instructions manual - Page 5
5
Maytag Cabrio,- WED7300X Installation instructions manual - Page 6
6
Maytag Cabrio,- WED7300X Installation instructions manual - Page 7
7
Maytag Cabrio,- WED7300X Installation instructions manual - Page 8
8
Maytag Cabrio,- WED7300X Installation instructions manual - Page 9
9
Maytag Cabrio,- WED7300X Installation instructions manual - Page 10
10
Maytag Cabrio,- WED7300X Installation instructions manual - Page 11
11
Maytag Cabrio,- WED7300X Installation instructions manual - Page 12
12
Maytag Cabrio,- WED7300X Installation instructions manual - Page 13
13
Maytag Cabrio,- WED7300X Installation instructions manual - Page 14
14
Maytag Cabrio,- WED7300X Installation instructions manual - Page 15
15
Maytag Cabrio,- WED7300X Installation instructions manual - Page 16
16
15
3. Remove the 4 screws from the opposite side of the door.
4. Install the 2 hinges to the front panel of the dryer using
4 screws. Use the non-slotted side to attach the hinge to the
fr
ont panel.
5. Instal
l screws in top hinge holes in the door. Do not tighten
screws. Leave approximately 1/4" (5 mm) of screw exposed.
6. Hang door by placing screw heads into top slotted holes of
hinges and slide door down. Align bottom screw holes in
hinge and door. Install two bottom screws. Tighten all hinge
screws.
7. Close door to engage door strike.
TROUBLESHOOTING
First try the solutions suggested here and possibly avoid the cost of a service call...
Dryer Operation
Dryer will not run
Has a household fuse blown, or has a circuit breaker
tripped?
There may be 2 household fuses or circuit breakers for the dryer.
Check that both fuses are intact and tight, or that both circuit
breakers have not tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
Is the correct power supply available?
Electric dryers require 240-volt power supply. Check with a
qual
ified electrician.
Was a regular fuse used?
Use a time-delay fuse.
No heat
Has a household fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you
may not have heat. Electric
dryers use 2 household fuses or circuit breakers. Replace the
fuse or reset the circuit breaker. If the problem continues, call an
electrician.
Dryer displaying code message
“PF” (power failure), check the following:
Was the drying cycle interrupted
by a power failure?
Press and hold START to restart the dryer.
“L2” Diagnostic Code (low or no line voltage condition):
The drum will turn, but there may be a problem with your home
power
supply keeping the dryer's heater from turning on. The
dryer will continue to run when this diagnostic code is present.