Maytag W10267633A Installation Instructions Manual

Download Installation instructions manual of Maytag Cabrio,- WED7300X Dryer for Free or View it Online on All-Guides.com. This version of Maytag Cabrio,- WED7300X Manual compatible with such list of devices, as: Cabrio,- WED7400X, Cabrio,- WED7800X, MGDB800VU - Bravos Steam Gas Dryer, W10267633A, WED5100

Maytag Cabrio,- WED7300X Installation instructions manual - Page 1
1
Maytag Cabrio,- WED7300X Installation instructions manual - Page 2
2
Maytag Cabrio,- WED7300X Installation instructions manual - Page 3
3
Maytag Cabrio,- WED7300X Installation instructions manual - Page 4
4
Maytag Cabrio,- WED7300X Installation instructions manual - Page 5
5
Maytag Cabrio,- WED7300X Installation instructions manual - Page 6
6
Maytag Cabrio,- WED7300X Installation instructions manual - Page 7
7
Maytag Cabrio,- WED7300X Installation instructions manual - Page 8
8
Maytag Cabrio,- WED7300X Installation instructions manual - Page 9
9
Maytag Cabrio,- WED7300X Installation instructions manual - Page 10
10
Maytag Cabrio,- WED7300X Installation instructions manual - Page 11
11
Maytag Cabrio,- WED7300X Installation instructions manual - Page 12
12
Maytag Cabrio,- WED7300X Installation instructions manual - Page 13
13
Maytag Cabrio,- WED7300X Installation instructions manual - Page 14
14
Maytag Cabrio,- WED7300X Installation instructions manual - Page 15
15
Maytag Cabrio,- WED7300X Installation instructions manual - Page 16
16
14
All Models:
13. Select a Timed Dry heated cycle, and start the dryer. Do not select
the Air Only Temperature setting.
If the dryer will not start, check the following:
Controls are set in a running or “On” position.
Start button has been pushed firmly.
Dryer is plugged into an outlet and/or electrical supply
is connected.
Household fuse is intact and tight, or circuit breaker has
not tripped.
Dryer door is closed.
This dryer automatically runs an installation diagnostic routine at the
start of its fir
st cycle.
If you receive an L2 code, there may be a
problem with your
home power supply keeping the dryer’s heater from turning on.
See “Troubleshooting.”
If you receive an AF code, your dryer vent may be crushed or
blocked. See “T
roubleshooting.”
NOTE:
You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.
REVERSE DOOR SWING
You can change your door swing from a right-side opening to a
left-side opening, if desired.
1. Pla
ce a towel or soft cloth on top of dryer or work space to
avoid damaging the surface.
Remove the door assembly
1. Open the dryer door.
2. Remove the bottom scr
ew from each of the 2 hinges that
attach dryer door to front panel of dryer.
3. Loosen the top scr
ew from each of the 2 hinges in Step 2.
A
B
A
B
A. Loosen these screws.
B. Remove these screws.
4. Remove the dryer door and the hinges by lifting upward on
the door. Lay the door on a flat, protected surface, with the
inside of the door facing up. Remove remaining 2 loose
scr
ews from dryer front panel.
5. Remove the
4 plastic plugs located outside the dryer door
opening.
6. Install 4 plastic plugs into screw holes in the dryer left where
the hinges were removed in Step 4.
Reverse the strike
1. Remove the door strike from the dryer door opening.
2. Re
move the cosmetic screw opposite the door strike.
A
B
A. Door strike
B. Cosmetic screw
3. Reinstall the door strike and cosmetic screw on the opposite
side of the dryer door opening from where they were
removed.
NOTE: Door strike and
plugs must be on the same side of the
dryer door opening.
Reinstall the door
1. Remove the 4 screws and 2 hinges from the dryer door.
2. R
eplace the 4 screws in the same holes.