• Home
• Brands
• Lowrance Manuals
• Lowrance X86 DS
• Lowrance X86 DS Installation And Operation Instructions Manual

Lowrance X86 DS Installation And Operation Instructions Manual

Download Installation and operation instructions manual of Lowrance X86 DS GPS for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

41

42

43

44

45

46

47

48

49

50

51

52

53

54

55

56

8

Lack of angle adjustment can be particularly troublesome on hulls that

sit with the bow high when at rest or at slow trolling speeds.

Third, a transducer CAN NOT shoot through wood and metal hulls.

Those hulls require either a transom mount or a thru-hull installation.

Fourth, if your Skimmer transducer has a built in temp sensor, it will

only show the temperature of the bilge, not the water surface temp.

Follow the testing procedures listed in the shoot-thru-hull installation

section at the end of this instruction booklet to determine if you can

satisfactorily shoot through the hull.

Transom Transducer Assembly and Mounting

The best way to install the transducer is to loosely assemble all of the

parts first, place the transducer's bracket against the transom and see if

you can move the transducer so that it's parallel with the ground.

1. Assembling the bracket. Press the two small plastic ratchets into the

sides of the metal bracket as shown in the following illustration. Notice

there are letters molded into each ratchet. Place each ratchet into the

bracket with the letter "A" aligned with the dot stamped into the metal

bracket. This position sets the transducer's coarse angle adjustment for a

14° transom. Most outboard and stern-drive transoms have a 14° angle.

Align plastic ratchets in bracket.

2. Aligning the transducer on the transom. Slide the transducer

between the two ratchets. Temporarily slide the bolt though the

transducer assembly and hold it against the transom. Looking at the

transducer from the side, check to see if it will adjust so that its face

is parallel to the ground. If it does, then the "A" position is correct for

your hull.

If the transducer's face isn't parallel with the ground, remove the

transducer and ratchets from the bracket. Place the ratchets into the

holes in the bracket with the letter "B" aligned with the dot stamped

in the bracket.

Reassemble the transducer and bracket and place them against the

transom. Again, check to see if you can move the transducer so it's

parallel with the ground.

Dot