Lightolier LSBW-6 Specification Sheet
Download Specification sheet of Lightolier LSBW-6 Indoor Furnishing for Free or View it Online on All-Guides.com.
Brand: Lightolier
Category: Indoor Furnishing
Type: Specification sheet for Lightolier LSBW-6
Pages: 2
1
2
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems LSBW-6
1BHFPG -ZUFTQSFBEÜ-4#1JFSDFE8BMM.PVOU-JHIU51FS'PPU/PNJOBM4FDUJPO
#
Features
1. Housing: Extruded aluminum. Die-cast end cap mechanically attached with
no exposed fasteners or hardware.
2. Lamping: Two T5, 28 or 54 watt (as specified) fluorescent lamps per 4-foot
nominal section. Provided by others.
3. Reflector: Precision die-formed, semi-specular aluminum.
Electrical
Ballast - <10% T.H.D., .98 ballast factor, pre-heat start. 18 gauge wire. Color-
coded quick connectors allow ease of connection for joiner modules. For special
circuiting, consult factory. Factory installed ballast disconnect allows the ballast
to be disconnected from and reconnected to incoming power under load without
turning the entire circuit off.
Dimming -
120/277 VAC, 1% dimming level.
Emergency Battery Pack - 28 Watt: 520 Lumens @ 90 min.
54 Watt: 700 Lumens @ 90 min.
Ordering Instructions
Individual Fixtures:
1. Order number of MODULES required.
2. Order one END SET per MODULE.
Continuous Rows:
1. Determine run length.
2. Order the appropriate number of MODULES to complete the run.
3. Order one END SET per run.
Labels
UL, cUL and I.B.E.W.
Complete ordering instructions below.
Ordering Information
Type Lamps Length Shielding Ballast Voltage Finish
2 = 2-Lamp T5 4 = 4-Foot B = Pierced 28 = 28W T5 1 = 120 Volt AL = Aluminum
8 = 8-Foot 54 = 54W T5 2 = 277 Volt WH = White
5E = 54W T5 Emergency Pack
2E = 28W T5 Emergency Pack
5D = 54W T5 Dimming
LSBW 2 B
Mountings
Dual-screw, draw-tight connector to create hairline seam between joiner modules.
Finish
Powder coated baked white or aluminum finish.
Custom colors available, consult factory.
4. Shielding: Precision die-formed, pierced 20 gauges CRS Piercing is four rows
that extend the entire length of the lamps. The pattern is 5/8” (1.59cm) x 1/16”
(0.16cm) slot with a 3/16” (0.48cm) separation between rows.
11-3/8" (28.89cm)
8-1/2" (21.59cm)
1-3/4"
(4.45cm)
3-1/2" (8.89cm)
12 3
Pierce Pattern
1/16" (0.16cm)
5/8" (1.59cm)
3-1/16" (7.78cm)
3/16" (0.48cm)
4