Knoll UBXX-HDMI Installation Instructions

Download Installation instructions of Knoll UBXX-HDMI Accessory for Free or View it Online on All-Guides.com.

Brand: Knoll

Category: Accessory

Type: Installation instructions for Knoll UBXX-HDMI

Pages: 2

Download Knoll UBXX-HDMI Installation instructions

Knoll UBXX-HDMI Installation instructions - Page 1
1
Knoll UBXX-HDMI Installation instructions - Page 2
2
Wiring: A Knoll HDMI
transmit balun needs to
be connected to a Knoll
receive balun to work
correctly. The transmit
and receive modules
are connected using
two cat 5e or cat 6
wires using all 8 conductors in each. Connection is made with the RJ45
connectors (RJ45 plug not supplied). Always use standard 568-A cat 5 wiring
practices (shown above). Using the correct wire pairs and polarity is VERY
important.
Make absolutely sure the VIDEO port (1) on the transmit unit is connected to
the VIDEO port (1) on the receive unit. Likewise the DDC port (2) on the transmit
unit is connected to the DDC port (2) on the receive unit. Both wires are
needed.
Please note the maximum cat5e or cat6 wire length for reliable
operation of 1080p is 100 feet or 30 meters. Do not attempt
a longer length as it may not be reliable. For lower resolutions
such as 720p or 1080i the maximum length is 130 feet or 40
meters. Cat 5e and cat 6 wires should be as short as possible.
Never run the cat 5e or cat 6 wires near or along side high
voltage wires. If high voltage lines are near by cross the cat 5e
or cat 6 wires to them at 90 degree angles.
Never coil up cat 5e or cat 6 wires. This can increase the
inductance of the wire and may give an unreliable picture.
Connection to HDMI source equipment: Connect the HDMI IN module
connectors with as short as possible HDMI cord to the source equipment. Less
than 2 meters (6’) is best. The maximum length the HDMI cables (not the Cat5e
wires) to the input and output combined is about 35’ (10 meters).
Make sure a good quality RJ45 8-8 crimper is used to
connect the RJ45 connector to the cat 5 wire. Poor crimping
and mismatched wires are the most frequent cause of
installation problems.
Power requirements: The Knoll UBXX-HDMI balun system is powered on the
receiver with the supplied power 5VDC power supply. Do not use any other
power supply than the one supplied in the pack.
Connection to the Projector, TV or other components: Connect the shortest
possible HDMI cable from the receive balun to the projector, TV or other
component. The maximum length the HDMI cables to the input and output
combined is about 35’ (10 meters).
Note: The UBXX-HDMI balun system is not compatible with other Knoll balun
systems. This balun system is not 3D ready. If 3D is required please use one of
other dual or single wire balun solutions. May not work with 36 bit deep color
(may need to change source to 1080i).
Connecting Infrared: The infrared receiver (three conductor jack) packaged
with the UBXX-HDMI can be connected on HDMI receiver module only. The
infrared emitter (two conductor jack) is connected to the HDMI IN module only.
External power supply and connection box is not required. 38 kHz transmission
only.
If problems are experienced with this product, please call our tech line for help
at 1 800 566 5579.