Audiovox PRO-9642 Specification

Download Owner's manual of Audiovox PRO-9342FT3 PurSuit Series Car Alarm for Free or View it Online on All-Guides.com.

Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 1
1
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 2
2
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 3
3
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 4
4
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 5
5
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 6
6
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 7
7
Audiovox PRO-9342FT3 PurSuit Series Owner's manual - Page 8
8
Page 4
þ Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the LED to identify which
zone was triggered.
þ Siren/Horn does not sound.
If the siren and or horn sounds 4 chirps, then the alarm was triggered in
your absence. Before turning the key on, examine the LED and refer to the
INTRUSION WARNING SIGNALS section of this manual to identify which
zone was triggered.
o Doors Unlock - Optional
WHILE THE SYSTEM IS SOUNDING
If during a triggered state, you wish to shut off the siren without disarming your security system,
simply press and release any transmitter button other than the disarm button. This action will
turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly
useful if you are aware of children playing near your vehicle that may accidently trigger your
security system. In this case you can cancel the siren sounding without disarming your security
system.
INTRUSION WARNING SIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from the
vehicle. If an intrusion attempt has occurred, the siren/horn will chirp 4 times and the parking
lights will flash 3 times when disarming the system. Enter the vehicle and observe the red dash
mounted LED to identify which zone was triggered.
If the LED is flashing one time...pause...one time...pause...etc., then an intrusion
attempt was made to the optional shock sensor, or an accessory triggering device
that may have been added to the system.
If the LED is flashing two times...pause...two times...pause...etc., then an intrusion
attempt was made to a hood or trunk pin switch that was added to the system, or to a
light activated entry point if the alarm was installed using the voltage sensing feature.
If the LED is flashing three times...pause...three times...pause...etc., then an intrusion
attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory and will only be erased
when the ignition key is turned on.
VALET SWITCH
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm functions are bypassed, however the remote panic feature and remote door
locks will remain operational. To use the valet mode, the system must first be disarmed either
by using your keychain transmitter or by overriding the system, then:
1. Enter the vehicle and turn the ignition key to the on position.
2. Press and hold the valet pushbutton switch until the dash mounted LED turns on
solid. The system will remain in the valet mode.