Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual
Download Configuration manual of Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Other for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Other
Type: Configuration manual for Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN
Pages: 290
Download Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration manual
ifconfig (JCS Switch Module)
Syntax ifconfig -T system:switch[x] <-c static> <-em (enabled | disabled)> <-ep (enabled |
disabled)> <-g gateway-address> <-i static-ip-address> <-s subnet-mask>
Release Information Command supported by Junos OS Release 9.1 and later.
Description (JCS management module CLI) Configure or display the JCS switch module Ethernet
interface.
Options -T system:switch[x]—Specify a JCS switch module as the command target. Replace x
with the primary management module number (1 or 2). The JCS switch module is the
only valid target available for this command.
NOTE: For redundancy, you must configure the Ethernet interface for both
JCS switch modules.
-c static—(Optional) Specify static IP configuration.
-em (enabled | disabled)—(Optional) Enable or disable external management of all ports
on the JCS switch module.
-ep (enabled | disabled)—(Optional) Enable or disable external ports on the JCS switch
module.
-g gateway-address—(Optional) Gateway IP address of the Ethernet interface on the JCS
switch module.
-i static- ip-address—(Optional) Static IP address of the Ethernet interface on the JCS
switch module.
-s subnet-mask—(Optional) Subnet mask of the Ethernet interface on the JCS switch
module.
Required Privilege
Level
operator (display)
supervisor (display or configure)
Related
Documentation
Configuring the Switch Module Ethernet Interface on page 41•
List of Sample Output ifconfig (Display) on page 68
ifconfig (Configure) on page 68
67Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Summary of JCS Management Module Configuration Commands