Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual
Download Configuration manual of Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Other for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Other
Type: Configuration manual for Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN
Pages: 290
Download Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration manual
• peer-interface ut-7/0/0.0—Bind the SONET and tunnel interfaces together.
• dlci 100—Configure the DLCI for the point-to-point Frame Relay connection.
• family inet address 10.10.10.1/24—Configure the IP version 4 (IPv4) suite protocol
family.
Results Display the results of the configuration:
interfaces {
ut-7/0/0 {
unit 0 {
peer-interface so-6/0/0.3;
}
}
so-6/0/0 {
encapsulation frame-relay;
shared-interface;
unit 3 {
peer-interface ut-7/0/0.0;
dlci 100;
family inet {
address 10.10.10.1/24;
}
}
}
Verification
•
Verifying Shared Interfaces on RSD3 on page 143
•
Verifying Shared Interfaces on PSD5 on page 145
•
Verifying Shared Interfaces on PSD6 on page 146
Verifying Shared Interfaces on RSD3
Purpose From RSD3, display the status of shared interfaces.
Action Issue the show interfaces so-6/0/0 command:
user@rsd3> show interfaces so-6/0/0
Physical interface: so-6/0/0, Enabled, Physical link is Up
Interface index: 128, SNMP ifIndex: 109
Link-level type: Frame-Relay, MTU: 4474, Clocking: Internal, SONET mode,
Speed: OC192, Loopback: None, FCS: 16, Payload scrambler: Enabled
Device flags : Present Running Down
Interface flags: Hardware-Down Point-To-Point SNMP-Traps Internal: 0x4000
Shared-interface : Owner
Link flags : No-Keepalives DTE
ANSI LMI settings: n391dte 6, n392dte 3, n393dte 4, t391dte 10 seconds
LMI: Input: 0 (never), Output: 0 (never)
DTE statistics:
Enquiries sent : 0
Full enquiries sent : 0
Enquiry responses received : 0
Full enquiry responses received : 0
DCE statistics:
143Copyright © 2010, Juniper Networks, Inc.
Chapter 14: Configuration Examples