Audioplex AUTO AMP-15 Installation Manual

Download Installation manual of Audioplex AUTO AMP-15 Amplifier for Free or View it Online on All-Guides.com.

Brand: Audioplex

Category: Amplifier

Type: Installation manual for Audioplex AUTO AMP-15

Pages: 2 (0.32 Mb)

Download Audioplex AUTO AMP-15 Installation manual

Audioplex AUTO AMP-15 Installation manual - Page 1
1
Audioplex AUTO AMP-15 Installation manual - Page 2
2
TECHNOLOGY
AUTO AMP-15
SPECIFICATIONS
INSTALLATION
WARRANTY
Connectors: Stereo Input/Output: Spring Clips / Television Input: RCA Jacks
Power supply: 24 VAC (supplied)
Switch: ON/OFF rocker switch
Amplifier Power: 15 Watts RMS, 45 Watts Audio
Power Handling: 500 Watts Audio
Dimensions: 12"W x 2.75"H x 5"D
Your AUTO AMP-15 is a free standing amplifier/switcher that allows your television audio signal to be
amplified and played through the home stereo speaker system. The unit can be triggered either from the
television's audio output or video output. When not in use, the home stereo signal passes through the AUTO
AMP-15 and is unaffected.
Connections to the system components (receiver, speakers and television) are illustrated on the back of
this sheet. Prepare the wires for connection by stripping about 3/16" from the ends. Twist strands tightly so that
no loose ends stick out to cause problems with short circuits. Make connections to the rear panel terminals by
pushing the connector tabs towards the chassis until the wire hole is fully open. Insert the wire and release the tab.
The unit must be turned on for television activation (stereo operation will be unaffected if unit is off). The
AUTO AMP-15 has controls for GAIN, SENSITIVITY, and DELAY. The GAIN control should be set by the
installer and left alone. With the television volume set at about 2/3rds, Set the GAIN control to a comfortable
level with no distortion. The SENSITIVITY control sets the signal level at which the unit switches from the
stereo system signal to the television signal (the sensitivity control has no affect on the video trigger, only the
audio trigger is affected).
The DELAY control sets the amount of time with no signal, before the unit switches back to the stereo system
(such as dead air between commercials, etc.).
Your AUDIOPLEX TECHNOLOGY AUTO AMP-15 is covered by a lifetime warranty against any
defects in workmanship and materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this
warranty. AUDIOPLEX TECHNOLOGY, is not responsible for defective operation caused by abuse or by
modification or service by any unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply. Any
necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The product must be returned expenses
prepaid, with written authorization from the company. The product must be shipped with the proof of purchase
and in the original carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
INSTALLATION MANUAL
1999 - 5/6/99