HP iPAQ h5400 Reference Manual
Download Reference manual of HP iPAQ h5450 Cell Phone, Handhelds for Free or View it Online on All-Guides.com.
Brand: HP
Category: Cell Phone , Handhelds , PDA
Type: Reference manual
Model: HP iPAQ h5450 , HP iPAQ h5455 , HP iPAQ Pocket PC h5400 Series
Pages: 258
3–6 Reference Guide
Using the Wireless LAN
4. Enter the profile information.
5. Tap Next.
6. Tap “Use server-assigned IP address” and use the DHCP
server address or select “Use specific IP address.”
Field Name Information
Profile Name Enter a name for your profile.
SSID This is the service set identifier (SSID) and the
default is “blank” when connecting to an
infrastructure network. This allows you to
connect to any available access point.
You and the wireless site you want to connect to
must use the same SSID. This identification
number uses a maximum of 32 characters and
is case sensitive.
Power Management The default selection is “No.” Selecting “Yes”
will provide lower performance and use less
power.
Network You have two choices: infrastructure or ad
hoc.The default selection is “Infrastructure.”
Use infrastructure to connect to a wired network
via a wireless access point.
Use ad hoc for peer-to-peer communications.
Channel The default is “Auto.”
You do not need to specify a channel if you are
using an infrastructure network. It will use the
same channel as the access point.
Otherwise, set the frequency that corresponds
to your country’s regulatory commission’s range
and the 802.11b standard.
Transmission Rate The default is “Auto.”
This is the wireless data transmission
speed. You can select speeds of 1, 2, 5.5,
or 11 Mbps.
281984-001.book Page 6 Thursday, September 26, 2002 5:05 PM