Hewlett-Packard P4000 Installation Instructions

Download Hardware installation instructions of HP StorageWorks P4000 Gateway, Network Storage Server for Free or View it Online on All-Guides.com.

Brand: HP

Category: Gateway , Network Storage Server , Server , Software , Storage

Type: Hardware installation instructions for HP StorageWorks P4000

Pages: 3 (0.69 Mb)

Download HP StorageWorks P4000 Hardware installation instructions

HP StorageWorks P4000 Hardware installation instructions - Page 1
1
HP StorageWorks P4000 Hardware installation instructions - Page 2
2
HP StorageWorks P4000 Hardware installation instructions - Page 3
3
HP StorageWorks
P4000 10GbE SFP+ Hardware
Installation Instructions
© Copyright 2009, 2010 Hewlett-Packard Development Company,
L.P.
Second edition: June 2010
The information in this document is subject to change without notice.
Printed in the US
www.hp.com
*AX705-96003*
Overview
This document describes how to upgrade the HP LeftHand P4000 to
10 Gigabit Ethernet (GbE). Upgrade instructions vary depending on
whether the HP LeftHand P4000 is new and/or whether it is already in
a management group.
Prerequisite
The motherboard BIOS firmware must be up-to-date with the latest version
installed.
Table 1 General upgrade steps for P4000s
Download the software patch
Download software patch 10073. This procedure is the same regard-
less of the state or location of the P4000 storage node.
1. Go to http://www.hp.com/support/storage.
2. Select P4000 SAN Solutions.
3. Select Disk Storage Systems > P4000 SAN Solutions > HP
LeftHand P4000 SAN Solutions.
4. Select Download drivers and software.
5. Select your product.
6. Select Cross operating system (BIOS, Firmware, Diagnostics, etc.).
7. Download the patch version 10073.
P4000 is in a management group
P4000 is new or not in a man-
agement group
Download the HP StorageWorks
P4000 G1 Series 1GbE to 10GbE
SFP+ Migration Guide.
Follow instructions in the Migration
Guide for planning the upgrade.
Install hardware using the HP
StorageWorks P4000 10GbE
SFP+ Hardware Installation In-
structions
Shut down the management group
using the instructions in the Migra-
tion Guide. Shutting down the
management group places it in
maintenance mode for the upgrade
process, and also powers off the
storage nodes, so that you can re-
move them from the rack.
Open the CMC and install
software patch 10073 onto the
P4000.
Install hardware using the 10GbE
SFP+ Hardware Installation Instruc-
tions.
Following instructions in the 1GbE
to 10GbE SFP+ Migration Guide
Open the CMC and install soft-
ware patch 10073 on the stor-
age node.
Configure network bonding on
the 10GbE ports if desired.
Installing the 10GbE board and RAM
Have the following items ready:
Page 1