Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
Figure 3-28 Connect the Power Module Cable
19. Place the processor airflow guide in position.
20. Install the chassis top cover. See “Installing the Top Cover” (page 30).
21. If necessary, reinstall the chassis in the rack. See “Install the Server into a Rack” (page 24).
22. Reconnect power and system cables to rear panel connectors.
23. Turn on the system.
24. Run the info cpu command at the EFI Shell prompt to verify that the processor has been
installed correctly.
Installing Memory
The server comes with four, eight, or twelve DIMMs installed. The server is minimally configured
with 1 GB of memory (four 256 MB DIMMs loaded in quad 0 (slots 0A, 0B, 1A, and 1B)). The
server is maximally configured with 24 GB of memory, four 2GB DIMMs loaded in each of quads
0, 1 and 2 (quad 0 slots 0A, 0B, 1A, and 1B, quad 1 slots 2A, 2B, 3A and 3B, and quad 2 slots 4A,
4B, 5A and 5B).
You can replace these DIMMs or insert DIMMs into unused quads to expand server memory.
When adding DIMMs, you must use a minimum of four like-sized DIMMs in the next available
quad.
Supported DIMM Sizes
Supported DIMM sizes are 256 MB, 512 MB, 1 GB, and 2 GB. You can use different DIMM sizes
in the server, but all four DIMMs in a quad must be identical.
Removing DIMMs
WARNING! Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions while performing DIMM removal. Failure to
follow ESD safety precautions can result in damage to the server.
To remove a DIMM, follow these steps:
Installing Memory 49