Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
6. If there are any empty sockets in the card cage, install a blank panel in the bulkhead opening
at the end of the card cage. The blank panel is necessary to ensure correct airflow when the
card cage is installed in a working server.
Installing a PCI Card
NOTE: You must remove the PCI card cage from the server chassis to enable installation of
PCI cards.
The four connectors in the PCI card cage are identical and have the same capabilities. You can
install a compatible PCI card in any slot.
To install a PCI card, follow these steps:
1. Remove the PCI card cage from the server chassis. See “Removing the PCI Card Cage
Assembly” (page 34).
2. Remove the cover from the PCI card cage.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure
to follow ESD safety precautions can result in damage to the server.
3. If there is a blank panel installed at the end of the card cage (for the card position/socket
which will be used), remove the blank panel.
4. Grasp the card by opposite edges and orient the card so that its connector is aligned with
the card cage socket, and the PCI-X interface connector is extended through the opening at
the end of the card cage. Insert the card into the desired socket.
5. Secure the card in the card cage using the retaining screw provided.
6. Connect any cables (if appropriate) to the card.
Installing the PCI Card Cage Assembly
To install the PCI card cage assembly, follow these steps:
WARNING! Ensure that the system is powered down and all power sources have been
disconnected from the server prior to removing or replacing the PCI card cage assembly.
Voltages and hazardous energy can be present at various locations within the server whenever
a power source is connected. This hazard is present even when the power switch is in the off
position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
1. If the card cage cover is removed, insert the cover tabs at the fan end of the cover into the
corresponding slots on the card cage, and press the cover into position on the card cage.
Slide the cover toward the front of the card cage to secure the cover in place.
2. Orient the PCI card cage as shown in Figure 3-11. Lift the release lever and hold it in the
open position. Lower the card cage into position and press gently to seat the card cage
connectors.
36 Installing Additional Components