Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
6. Place the card cage on an ESD-protected work surface.
7. Orient the card cage such that PCI card connectors (within the card cage) are at the bottom,
when viewed through the open side of the card cage, and cards can be removed by lifting
them from the sockets.
8. Remove the cover that is now on top of the card cage by sliding the cover toward the rear
of the card cage and lifting the cover. Remove the cover from the card cage.
NOTE: The four connectors within the card cage are identical and have the same capabilities.
You can install a compatible PCI-X card in any slot.
Removing a PCI Card
NOTE: You must remove the PCI card cage from the server chassis to access the PCI cards.
To remove a PCI-X card, follow these steps:
1. Remove the PCI card cage from the server chassis. See “Removing the PCI Card Cage
Assembly” (page 34).
2. Remove the cover from the PCI card cage.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure
to follow ESD safety precautions can result in damage to the server.
3. If a cable blocks card removal, or if it is connected to the card, disconnect the cables from
the card connectors.
4. Use the ACX-15 Torx screwdriver to remove the retaining screws (M3 x 6mm long pan
T15/slot squire cone stainless steel) that secures the card in place (Figure 3-10).
Figure 3-10 PCI Card Retaining Screws
pciccscrw2
Card
Retaining
Screws
5. Grasp the card by the two opposite edges and lift the card from the socket.
PCI Card Installation 35