Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
4. Locate the system battery on the system board (Figure 7-45).
CAUTION: Do not overstress the battery retaining clip. This clip is easily broken. Lift the
battery just high enough to clear the battery holder. Failure to heed this warning can result
in damage to the clip.
5. Remove the battery by lifting the retaining clip and pulling the battery from its socket.
WARNING! Lithium batteries can explode if mistreated. Do not recharge, disassemble, or
dispose of batteries in a fire. When discharged, do not throw batteries away; collect them
as small chemical waste. Failure to observe this warning can result in personal injury or
damage to equipment.
Installing the System Battery
WARNING! Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions when working inside the server. Failure to
follow ESD safety precautions can result in damage to the server.
To install the system battery, follow these steps:
1. Remove the top cover from the chassis. See “Removing and Replacing the Top Cover”
(page 123).
162 Removing and Replacing Components