Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
Figure 7-37 Processors in Server Chassis
chastop2cpus
CPU 0
CPU 1
F
R
O
N
T
WARNING! Ensure the system is powered down and all power sources have been disconnected
from the server prior to removing or replacing components.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions while performing processor removal. Failure
to follow ESD safety precautions could result in damage to the server.
NOTE: Installation instructions are provided with replacement processors. Read those
instructions carefully. Changes in processor design (and installation) may have occurred since
this procedure was written. Always follow the instructions provided with a replacement processor.
To replace a processor, follow these steps:
1. If rack-mounted, extend the server out from the rack until it stops. See “Installing Components
When the Server Is in a Rack” (page 114).
2. Turn off the system.
3. Disconnect all external cables.
4. Remove the server from the rack and place it on an ESD-protected work surface. See
“Removing the Server From a Rack” (page 115).
5. Remove the chassis top cover. See “Removing and Replacing the Top Cover” (page 123).
6. Remove the processor airflow guide. See “Removing the Processor Airflow Guide” (page 128).
7. Insert the IPF-CPU tool into the processor locking mechanism and rotate it to the unlocked
position (Figure 7-38).
Removing and Replacing a System Processor 155