Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
Figure 7-20 Hard Drive Backplane
Fault
DC Out DC In
chasfn5out2
Mounting Screws
Backplane Mounting Screws
12. Slide the backplane board to the right to align locking holes in the unlocked position, and
remove the board.
Installing the Hard Drive Backplane
To install a hard drive backplane, follow these steps:
1. Insert the hard drive backplane through the fan opening in the chassis rear panel.
2. Position the hard drive backplane on the four locating posts and slide the board to the left
until it latches in the locked position.
3. Secure the hard drive backplane in place with the two mounting screws (Figure 7-20).
4. Connect the three cables to the corresponding connectors on the hard drive backplane.
5. Place the inner bulkhead panel in position (Figure 7-19).
6. Reinstall the fan power cable connector onto the bulkhead panel, and position the bulkhead
panel in to place in front of the installed hard drive backplane assembly. Tighten the two
captive screws to secure the panel.
IMPORTANT: Make sure to reinstall the fan power connector on the bulkhead panel with
the arrow pointing down so it can make contact with the connector on the rear fan.
7. Install the system board. See “Installing the System Board” (page 165).
8. Install the rear fan module. See “Installing a Rear Panel Hot-Swappable Fan” (page 127).
9. Install the disk drives or fillers. See “Installing Disk Drives” (page 24).
140 Removing and Replacing Components