Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
3. Remove the server from the rack and place it on an ESD-protected work surface. See
“Removing the Server From a Rack” (page 115).
WARNING! Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure
to follow ESD safety precautions can result in damage to the server.
4. Remove the top cover from the chassis. See “Removing and Replacing the Top Cover”
(page 123).
5. Pull up on the PCI card cage release lever and the back edge of the card cage.
Figure 7-14 Removing the PCI-X Card Cage
chaspciccdwn
Release
Lever
PCI Card Cage
6. Lift straight up on the card cage without rocking to remove it from the server chassis.
7. Place the card cage on an ESD-protected work surface.
8. Orient the card cage so that PCI card connectors within the card cage are at the bottom,
when viewed through the open side of the card cage.
9. Remove the cards by lifting them from the sockets.
10. Remove the cover that is now on top of the PCI card cage by sliding the cover toward the
rear of the card cage and lifting the cover to remove the cover from the card cage.
132 Removing and Replacing Components