Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
2. Squeeze inward on the release clip and pull the release lever to pull the drive from the server
chassis.
Figure 7-3 Disk Drives in Server
dskdrvfrnt1
2
1
0
S
C
S
I
Release
Clip
Release
Lever
Installing Hot-Plug Disk Drives
To install a hot-plug disk drive, follow these steps:
1. If required, (OS does not support hot-plugging) stop the operating system.
2. If a disk filler is installed, remove it by pulling the dummy release lever.
3. With the release lever pulled out, slide a hot-plug hard disk into the disk slot until it is
seated.
4. Press the release lever until it is flush with the front of the server. The release lever clicks as
it locks into position.
5. If the operating system was stopped in step Step 1, reset the system to the EFI Boot
Maintenance Menu to rescan the hard drives.
6. If the operating system was stopped in step Step 1, use the EFI Shell map command to verify
that you correctly installed the newly inserted drive. Refer to “Troubleshooting” (page 53)
and “Utilities” (page 73), for information about connecting a console and using the EFI shell.
Removing and Replacing Hot-Swappable Power Supplies
Hot-swappable power supplies 1 and 2 are located at the rear of the chassis. These power supplies
are identical and interchangeable.
118 Removing and Replacing Components