Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
Table 5-3 (continued)
DescriptionCommand
Paging parameter setupPG
Power management module statusPS
Reset BMCRB
Reset system through RST signalRS
Set accessSA
Enter OS sessionSE
Show event logsSL
Security optionsSO
System processor statusSS
Current system firmware revisionsSYSREV
Reset via transfer of control (TOC)TC
Tell- send a message to other usersTE
User configurationUC
Virtual front panelVFP
Display connected management processor usersWHO
Exit management processor and disconnectX
Diagnostics and/or reset of management processorXD
Reset BMC Passwords
BP: Reset BMC Passwords
This command resets BMC passwords (both USER and ADMIN passwords).
Configure Serial Port Parameters
CA: Configure local and remote serial port parameters
Set up the local serial port parameters as follows:
• TERMINAL TYPE: VT100 vs HPterm
• BAUD RATES: Input and output data rates are the same; 300, 1200, 2400, 4800, 9600, 38400,
115200 bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; Software uses Xon/Xoff.
• TRANSMIT CONFIGURATION STRINGS: Disable this setting whenever the modem being
used is not compatible with the supported modem (MT5634ZBA).
IMPORTANT: Do not mix HP and VT100 terminal types at the same time.
Set up the remote serial port parameters as follows:
• MODEM PROTOCOL: Bell or CCITT (CCITT is a European standard; RTS/CTS signaling
is used, as well as the Ring signal. Bell is a U.S. or simple mode).
• BAUD RATES: Input and output data rates are the same; 300, 1200, 2400, 4800, 9600, 38400,
115200 bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; Software uses Xon/Xoff.
100 Utilities