Hewlett-Packard 9g - Graphing Calculator User's Manual
Download Operation & user’s manual of HP 9g Calculator, Power Supply for Free or View it Online on All-Guides.com.
Brand: HP
Category: Calculator , Power Supply
Type: Operation & user’s manual
Model: HP 9g , HP F2222A#ABA - 9s Scientific Calculator
Pages: 172 (5.43 Mb)
E-29
⇒
The SWAP command swaps the contents in two memory variables.
Relational Operators
The relational operators that can be used in FOR loops and conditional
branching are:
= = (equal to), < (less than), > (greater than),
≠
(not equal to),
≤
(less
than or equal to),
≥
(greater than or equal to).
Creating a New Program
1. Select NEW from the program menu and press [ ].
2. Select the calculation mode you want the program to run in and press
[ ].
3. Select one of the ten program areas (P0123456789) and press [ ].
4. Enter your program’s commands.
• You can enter the calculator’s regular functions as commands.
• To enter a program control instruction, press [ 2nd ] [ INST ] and
make your selection.
• To enter a space, press [ ALPHA ] [ SPC ].
5. A semicolon (;) indicates the end of a command. To enter more than
one command on a command line, separate them with a semicolon. For
example:
Line 1:
INPUT
A ; C = 0.5
×
A ;
PRINT
” C = ” , C ;
END
You can also place each command or group of commands on a
separate line, as follows. In this case, a trailing semicolon can be
omitted.
Line 1:
INPUT
A ; C = 0.5
×
A [ ]
Line 2:
PRINT
” C = ” , C ; END
Executing a Program
1. When you finish entering or editing a program, press [
CL
/
ESC
] to return
to the program menu, select RUN and press [ ]. (Or you can press
[ PROG ] in MAIN mode.)
2. Select the relevant program area and press [ ] to begin executing
the program.
3. To re-execute the program, press [ ] while the program’s final
result is on the display.
4. To abort the execution of a program, press [
CL
/
ESC
]. A message
appears asking you to confirm that you want to stop the execution.
STOP : N Y
Press [ ] to move the cursor to Y
and then press [ ].