• Home
• Brands
• Smeg Manuals
• Smeg FC345B
• SMEG FC345B Instructions For Use Manual

SMEG FC345B Instructions For Use Manual

Download User manual manual of Smeg FC345B Freezer for Free or View it Online on All-Guides.com. This version of Smeg FC345B Manual compatible with such list of devices, as: FC345S, FC395S, FC395S1, FC395X, FC395X1

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

142468

Required tools: socket spanner nr. 8, screwdriver, torx 25.

Caution! After unscrewing of before fi xing hinges, hold the door

to prevent it from falling and damaging.

1. Remove upper hinge cover (save it for eventual later use),

remove also the cover on the opposite side of the upper hinge

cover (on the opposite side you will insert the attached cover

during the assembly), and remove the cover on the opposite

side of the upper part of the door.

2. Unscrew upper hinge screws and remove the upper door from

the middle hinge.

3. On the bottom side of the upper door unscrew the swing

stopper screws and remove the stopper (A). Keep this for

eventual use later on. Fix the attached stopper with its

bearing on the opposite side of the door.

4. Unscrew the forced door closure system (B) and fi x it to the

opposite side of the door (certain models only).

5. Unscrew middle hinge screws, remove the door from bottom

hinge.

6. Loosen the screws fi xing the leg supports (certain models

only), then continue the procedure either under cf. 7 or 7.1,

depending on the model of the appliance.

7. Tilt the appliance backward (max. 35°) to lean to the rear

side of the cabinet. Unscrew the leg support screws (C) - left

and right, and remove the leg support cover (D) and place it

to the opposite side. Unscrew and remove, then reciprocally

replace the position of end switch (E) and decorative peg (F)

(for models with forced door closing system). Unscrew three

screws fi xing the bottom hinge (save the hinge for later use),

and fi x the attached bottom hinge on the opposite side.

7.1. Tilt the appliance backwards (max. 35°) to lean on the

housing at the back.

Loosen three screws holding the bottom hinge (save the

hinge for eventual subsequent door swing change). On the

opposite side affi x the attached bottom hinge. Plug the holes

left after the replacement with relevant pegs.

8. Repeat the procedure 3 and 4 on the bottom door. In case

there is no bottom door limit peg, transfer the bearing (G) and

washer to the opposite side of the door.

9. Proceed with the assembly procedure in opposite sequence.

Remark:

• At OLD TIMER appliances (in the model marking …O…)

alteration of door opening direction is not possible.

9

Reverse door swing