SMEG SE2320ID Instructions Manual

Download Instructions for fitting and use of Smeg SE2320ID Cooktop, Hob for Free or View it Online on All-Guides.com.

Brand: Smeg

Category: Cooktop , Hob

Type: Instructions for fitting and use for Smeg SE2320ID

Pages: 17 (0.66 Mb)

Download Smeg SE2320ID Instructions for fitting and use

Smeg SE2320ID Instructions for fitting and use - Page 1
1
Smeg SE2320ID Instructions for fitting and use - Page 2
2
Smeg SE2320ID Instructions for fitting and use - Page 3
3
Smeg SE2320ID Instructions for fitting and use - Page 4
4
Smeg SE2320ID Instructions for fitting and use - Page 5
5
Smeg SE2320ID Instructions for fitting and use - Page 6
6
Smeg SE2320ID Instructions for fitting and use - Page 7
7
Smeg SE2320ID Instructions for fitting and use - Page 8
8
Smeg SE2320ID Instructions for fitting and use - Page 9
9
Smeg SE2320ID Instructions for fitting and use - Page 10
10
Smeg SE2320ID Instructions for fitting and use - Page 11
11
Smeg SE2320ID Instructions for fitting and use - Page 12
12
Smeg SE2320ID Instructions for fitting and use - Page 13
13
Smeg SE2320ID Instructions for fitting and use - Page 14
14
Smeg SE2320ID Instructions for fitting and use - Page 15
15
Smeg SE2320ID Instructions for fitting and use - Page 16
16
Smeg SE2320ID Instructions for fitting and use - Page 17
17
Instructions for assembly
GB
30
Clips
Drive the clips into the worktop cut-out at
the intervals indicated. It is not necessary
to adjust the height due to the horizontal
stop.
Important! The horizontal drive of the clips
must be flush with the worktop (avoid the
risk of fractures)
Position the hob according to the
illustration on the left side (a), align it (b)
and insert the clips (c).
Screws may be used to fasten the clips.
Important!
There is a risk of breakage if the hob is
canted or subjected to stress during
installation!
Minimum distance to adjacent walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
Bracket
Insert the hob and align it.
From the bottom, insert the brackets with
screws in the holes provided for fastening
the brackets, align the brackets and screw
them tight.
Tighten the screws with a hand screw
driver only; do not use a battery-operated
screw driver.
In the case of thin worktops make sure
that the brackets are correctly positioned.
A metric screw must be used on the
bracket to balance it.
Important!
There is a risk of breakage if the hob is
canted or subjected to stress during
installation!
Minimum distance to adjacent walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
520
490
520
500