GE Profile JD968 Install Manual
Download Installation instructions manual of GE JD968 Cooktop, Welding System for Free or View it Online on All-Guides.com. This version of GE JD968 Manual compatible with such list of devices, as: JD968, JD968BKBB - Profile, JDP47BFBB, Profile PD900DP
Brand: GE
Category: Cooktop , Welding System
Type: Installation instructions manual
Model: GE JD968 , GE JD968BKBB - Profile , GE JDP47BFBB , GE Profile PD900DP
Pages: 16 (0.38 Mb)
1
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT—Save these
instructions for local inspector’s use.
• IMPORTANT—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under the warranty.
• NOTE—This appliance must be properly
grounded.
• ATTENTION INSTALLER
All electric drop-in ranges must be hard
wired (direct wired) into an approved
junction box. A plug and receptacle is NOT
permitted on these products.
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Self-Cleaning Radiant
Electric Drop-In Range
Installation
Instructions
JDP47, JD968, JD900
Materials Needed
Junction Box
Wire NutsStrain Relief Clamp
for 1/2” conduit
Parts Included
Lower Trim
2 Screws
2 Shoulder Screws
(for stop device)
Tools You Will Need
1/8” Drill Bit and
Electric or Hand Drill
Phillips Screwdriver
Nut Driver
Level
Tape Measure
Straight Edge
or Square
Hand or Sabre Saw
Standard Screwdriver
Pencil
Safety Glasses
Hammer
31-10622-1 1-07 JR