• Home
• Brands
• GE Manuals
• GE 36" CUSTOM HOOD INSERT ZVC36LSS
• GE 36" CUSTOM HOOD INSERT ZVC36LSS User Manual

GE 36" CUSTOM HOOD INSERT ZVC36LSS User Manual

Download Dimensions and installation information of GE 36" CUSTOM HOOD INSERT ZVC36LSS Ventilation Hood for Free or View it Online on All-Guides.com.

1

2

ZVC36LSS

GE Monogram

®

36" Custom Hood Insert

For answers to your Monogram,

®

GE Profile

™

or

GE

®

appliance questions, visit our website at

ge.com or call GE Answer Center

®

service,

800.626.2000.

Specification Created 10/06

Custom Insert Liner

The custom canopy must be sized to fit the insert sleeve.

Construct the canopy with an opening that is:

26"W x 13-3/16"D

The opening must be constructed of 3/4" thick material to

allow the sleeve locking clips to engage.

Dimensions and Specifications (in inches)

Outside Dimensions

The Insert Sleeve

The bottom edge of the insert sleeve has a 7/8" wide flange

on the sides and a 1/2" wide flange on the front and back.

Remote Location for the Control

The control may be removed from the hood and installed

into a wall or countertop. A 30-ft length of wire is supplied to

accommodate most installations. A blanking plate covers the

opening when the controls are removed. The overall size of

the control is 4-1/4" wide and 2-1/4" deep.

1-11/16"

3-11/16"

We recommend that the cutout in granite or other hard

surfaces be made before the countertop is installed.

The Supplied Liner

A stainless steel liner is shipped with each hood insert. This

non-combustible liner protects the underside of the canopy.

Custom Liner

If you are not using the supplied liner, you may construct a

custom non-combustible liner. Use the supplied liner as a

template. The opening must be 26"W x 13-3/16"D. 3/4" thick

material must surround the opening to allow the sleeve

locking clips to engage. The insert sleeve inside the cabinet

should be positioned 1/2" from the rear wall so that the

center of the 8" duct is 5-1/2" from the rear wall.

130674