GE Monogram ZDWI240WII Installation Instructions

Download Dimensions and specifications of GE Monogram ZDWI240WII Beverage Dispenser for Free or View it Online on All-Guides.com.

Brand: GE

Category: Beverage Dispenser

Type: Dimensions and specifications for GE Monogram ZDWI240WII

Pages: 3 (0.17 Mb)

Download GE Monogram ZDWI240WII Dimensions and specifications

GE Monogram ZDWI240WII Dimensions and specifications - Page 1
1
GE Monogram ZDWI240WII Dimensions and specifications - Page 2
2
GE Monogram ZDWI240WII Dimensions and specifications - Page 3
3
ZDWI240WII – GE Monogram
®
Wine Reserve
Dimensions and Specifications (in inches)
Installation Space
The cutout depth must be 24"
The cutout dimensions shown allow for a full door swing and access
to the pull-out racks when installed as a built-in.
The wine reserve can be free-standing.
Note: If installing between frameless cabinets, a 1/2" wide filler strip
or side panel may be required. The filler strip will act as a spacer
between the door case and adjacent cabinet and will prevent
interference with cabinet door swing. The width of the opening
must include filler panels.
Wine reserve is vented at the front toekick to allow built-in
undercounter installation.
• Door swing is reversible.
Additional Specifications:
A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual property grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical
must be located on rear wall as shown. Note: GFI (ground fault
interrupter) is not recommended.
For answers to your Monogram,
®
GE Prole
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Product Clearances
15" Minimum
110˚
Wall
24"
Cabinet
14" Minimum
110˚
Wall
24"
Cabinet
All models are factory set for a 11door swing.
For a minimum 9door swing:
Allow 4" min. clearance to wall on the hinge side.
For a full 110° door swing:
Allow 14" min. clearance to wall on the hinge side.
34-1/2"-35"
24" Min.
23-3/4"
23-3/4" Min.
25-1/2"
Including
Handle
34-1/4"-
34-3/4"
23-3/4" Stainless steel
models
24-1/8" Framed models
1-1/2"
Locate Outlet
9"
Max.
10-1/2"
Specification Created 10/07
120037