A D V A N C E D O P E R A T I O N
O P E R A T I O N
The date and time will appear in the display when
the unit is off. When the unit is turned on, the
screen will read: “SELECT MODE OR PRESS
S
TART TO SELECT PRESET”
To initiate any Quickchiller operating mode, power
must initially start from the
O
FF
position or an
operating mode must be halted by pressing the
START/STOP key so that the SELECTION
SCREEN appears on the display.
NOTE: With the exception of the QC-3 counter top
Quickchiller model, the Alto-Shaam name
on the control panel will illuminate
whenever the power key is pressed to the
ON position.
HOLD TEMP
Starting from the OFF position, press the
power key ON. The SELECTION SCREEN
will appear on the display. The compressor
will become energized and will begin to
operate if required by the sensors.
Press the HOLD TEMP key. The display
will indicate the default hold temperature
(changeable in User Settings).
To change the displayed temperature, press the
up or down arrow key to increase or decrease
the temperature display within the refrigeration
storage parameters of the Hold Temp mode -5°F to
+40°F (-21°C to +4°C).
NOTE: THE MODIFIED HOLDING TEMPERATURE SET-POINT
IS NOT SAVED. THE DEFAULT HOLD TEMPERATURE
CAN BE CHANGED UNDER USER SETTINGS.
Press the START/STOP key to begin
operation of the Quickchiller in the Hold
Temp mode.
The display will indicate:
1. The length of time the chiller is
operating in the Hold Temp mode.
2. The temperature set by the operator.
3. The air temperature inside the
chiller compartment.
4. The temperature of all food probes.
WHEN IN THE HOLD TEMP MODE
AFTER A CHILL MODE:
Press the UP arrow key to display the maximum
sensor temperature achieved during the completed
chill cycle. Press the DOWN arrow key to
display the minimum sensor temperature achieved
during the completed chill cycle. Press the
right or left arrow key to display the Probe
Done Time.